Self-Cleaning Mode - Maxwell MW-1951 Instruction Manual

ENGLISH
• Cover the bowl (7) with cover (1), leaving
the handle (4) in the upright position.
• Set the timer (3) and temperature con-
troller (5) into position according to the
cooking recipe.
• Push the knob (4) into horizontal posi-
tion, the heater unit turns on and indica-
tor (6) lights on.
After completion of the warm-up you will
hear the beep and the heating element
will turn off automatically.
NOTE:
- changing the time of the grill or cook-
ing temperature can be done when
aerogrill is on, it is sufficient to raise
the handle (4) of the cover (1) and set
the necessary parameters of time
and temperature.
- after taking the food-stuff out in or-
der to avoid condensation, do not
put cover (1)on the bowl (7), wait for
complete cooling of the glass bowl
(7).
NOTE:
- be careful! The surface of the glass
bowl (7) is heated during operation,
explain this to your children and do
not let them play near the device.
- if necessary, take aerogrill to anoth-
er location, unplug the appliance and
let it cool down, move aerogrill hold-
ing both its handles (12), if the bowl
is with hot oil or liquid one should be
extremely careful.
- at the end of operation disconnect
aerogrill from the power supply.
AEROGRILL MAINTENANCE
AEROGRILL CLEANING
- unplug the device and let it cool down
completely.
- wipe the upper part and a protective grill
cover (1) with a damp cloth or sponge
dipped in a neutral detergent, then wipe
MW-1951.indd 14 MW-1951.indd 14
it dry. Do not allow moisture inside of the
cover (1).
- with a very strong pollution of fan grate,
you must remove it by unscrewing the
three screws. Clear the grate by using
the hard sponge with detergent, or leave
for some time in a solution of special
cleaners for aerogrill. Before installing
the grate in place, thoroughly dry it.
- bowl (7) should be washed with neutral
detergent being careful.
- grates should be washed in water with a
neutral detergent.
NOTE:
- avoid contact of hot glass bowl with
cold water.
- never immerse the cover (1) in water
or any other liquid.

SELF-CLEANING MODE

- fill the bowl (7) with hot water, but not
more than half of the bowl and add a neu-
tral detergent.
- install the cover (1) on the bowl (7), tim-
er (3) should be set for 10 minutes, the
temperature controller (5) should be set
in the position of 65 ° C - 100 ° C.
- push the handle of the cover down to ac-
tivate the heating element.
- upon completion rinse the bowl (7) with
warm water, cover (1) should be wiped
with a soft cloth or towel.
NOTE:
- in self-cleaning mode dirty grates (8,
9) may be placed into bowl (7).
USING DISHWASHER
- glass bowl (7), grates (8, 9) and forceps
(10) may be washed in a dishwasher.
Before putting bowl (7) into dishwasher,
take it off the stand (12).
- never immerse the cover (1) in water or
any other liquid.
14
14.09.2010 15:11:55 14.09.2010 15:11:55