Advertisement
Quick Links
Advertisement
Summary of Contents for MobileDemand Surface Go
- Page 1 Surface Go Scanner Installation...
- Page 2 3 - Remove M3 x 8 & (2) M3 x 10 Flat Head screws. SG-SCN-ONLY-KIT-DFS. 2 - Install Tablet into the Case per instructions included with Case. Make sure the Scanner USB PCB does not extend into Case. ©2021 MobileDemand, LC | All trademarks are property of their respective owners.
- Page 3 5 - Re-install the M3 x 8 and 6 - Install the Scanner Connector Cover (2) M3 x 10 Flat Head screws. using (2) M2 x 3 Pan Head screws. ©2021 MobileDemand, LC | All trademarks are property of their respective owners.
- Page 4 Scanner only assembly for Surface Go USB Type C connector 7 - Locate USB Type C connector in tablet. 8 - Plug USB Type C PCB into USB Type C connector as shown. ©2021 MobileDemand, LC | All trademarks are property of their respective owners.
- Page 5 9 - Install Vanity Cover over USB Type C PCB. Ensure wires are aligned in 11 - Vanity Cover should look like Vanity Cover clearance area so that wires are not pinched. this when properly installed. ©2021 MobileDemand, LC | All trademarks are property of their respective owners.