Inspire 1 Pro Release Notes

2017.07.10
Overview:
1. All-in-One firmware version updated to v01.11.01.50.
2. Remote Controller firmware version updated to v1.7.80.
3. DJI GO app iOS version updated to v3.1.13.
4. DJI GO app Android version updated to v V3.1.8.
What's New:
1. Updated No Fly Zone Management.
2. For increased safety, the flight is restricted to a height of 30 m and distance of 50 m when not
connected or logged into the app during flight, including DJI GO and all apps compatible with DJI
aircraft.
3. Optimized gimbal performance to improve its stability during flight.
4. Optimized the Remote Controller to match the latest aircraft firmware.
Notes:
1. Make sure to update your aircraft and gimbal before updating the Remote Controller.
2. Make sure you restart both the aircraft and remote controller after updating them to the latest
firmware. Otherwise, video downlink may be unstable. Re-link the aircraft with the remote controller if
they are disconnected.
3. Please note that firmware update may reset various Main Controller Settings, such as the RTH Altitude
and Maximum Flight Distance, to factory defaults. Before the update, take note of your preferred DJI
GO settings, and readjust them after the update to suit your preference.
4. Aircraft version v01.11.01.50 and camera version v01.10.01.40 should be displayed in DJI GO. The
version will only display correctly in DJI GO after connecting to the Internet when upgrade is complete.
5. Remote controller version v1.7.80 or above should be used together. Make sure you update the remote
controller to version v1.7.80 or above. Please note that this remote controller firmware cannot be
downgraded.
© 2017 DJI. All Rights Reserved.
Inspire 1 Pro Release Notes