Model Description such applications does so at his/her own risk. 101B224-01 DIN rail mounting kit for two devices Ashcroft, Inc. shall not be held liable for damages resulting from such improper use. WARNING Cancer and Reproductive Harm - www.P65Warnings.ca.gov Limited Warranty Ashcroft, Inc.
Introduction ......................2 Ordering Information ................... 2 Specifications....................... 4 General (All) ..................... 4 101B224-06 RS-232 Adapter ................4 101B224-07 RS-485 Adapter ................4 101B224-08 USB Adapter ................4 101B224-09 USB to RS-232 Converter ............4 USB Drivers for Serial Communications Adapters ........4 DIN Rail Mounting Instructions ................
Cable One 6' (1.8 m) standard Cat5e cable and one 3.28' (1.0 m) USB A-B Male cable provided with adapter 101B224-06 RS-232 Adapter Dimension 1.7" x 0.8" x 3.3" Compatibility EIA-232 43 mm x 21 mm x 83 mm)
Serial Communication Adapters Instruction Manual mounting needs to be considered also. In many cases, DIN rail DIN Rail Mounting with double-sided tape might be acceptable, although not recommended in areas of high vibration or extreme hot or cold Instructions temperatures. The following instructions for expansion modules may be used for mounting the converters and adapters to DIN rails.
Serial Communication Adapters Instruction Manual Figure 9 illustrates how to connect a general four-wire Serial Communications network (a four-wire network actually contains 5 wires). Overview RS-232 and RS-485 are standard interfaces approved by the Electronic Industries Alliance (EIA) for connecting serial devices. In EIA terms, the device (e.g. meter) that connects to the interface is called a Data Communications Equipment (DCE) and the device to which it connects (e.g.
(Not Provided) Cat5e Cable Description (Provided) The 101B224-06 converts the serial output of the DM61 meter to an unbalanced, full-duplex RS-232 signal. Figure 11. RS-232 Adapter Connections The RS-232 port has a female DB9 connector with pins 2 (RX output), 3 (TX input), and 5 (Signal Ground). Pins...
Serial Communication Adapters Instruction Manual Notes: 101B224-07 RS-485 Serial Termination resistors are optional and values Adapter depend on the cable length and characteristic impedance. Consult the cable manufacturer for recommendations. Use shielded cable, twisted-pairs plus ground. Connect ground shield only at one location. Description The 101B224-07 converts the serial output of the DM61 meter to balanced, full or half-duplex RS-485 signals.
Figure 16 shows the connection of a DM61 meter to a PC using a 101B224-09 USB to RS-232 Converter, Figure 15 shows the connection of a DM61 meter to a 101B224-06 RS-232 adapter, and the included Cat5e PC using a 101B224-08 USB Serial Adapter. Cable.
Serial Communication Adapters Instruction Manual Troubleshooting Symptom Check/Action Power LED is off 101B224-06 or 101B224-07 Check modular cable connection Check wall plug adapter output Check USB connections Try different USB port Check USB port with other device Meter not Check:...
Need help?
Do you have a question about the 101B224-06 and is the answer not in the manual?
Questions and answers