Kogan KAWWASH9D6A User Manual page 4

•
That the tumble dryer is not to be used if industrial chemicals have been used for
cleaning.
•
That the lint trap must be cleaned frequently, if applicable.
•
That lint must not to be allowed to accumulate around the tumble dryer.
•
Do not dry unwashed items in the tumble dryer.
Installation
•
The appliance must be handled and installed by two or more persons – risk of injury.
Use protective gloves to unpack and install-risk of cuts.
•
Move the appliance without lifting it by the worktop or top lid.
•
Installation, including water supply (if any) and electrical connections and repairs must
be carried out by a qualified technician. Do not repair or replace any part of the
appliance unless specifically stated in the user manual. Keep children away from the
installation site. After unpacking the appliance, make sure that it has not been
damaged during transport. In the event of problems, contact help.kogan.com for
support assistance. Once installed, packaging waste (plastic, styrofoam parts etc.)
must be stored out of reach of children – risk of suffocation. The appliance must be
disconnected from the power supply before any installation operation – risk of electric
shock. During installation, make sure the appliance does not damage the power cable
– risk of fire or electric shock. Only activate the appliance when the installation has
been completed.
•
Do not install your appliance where it may be exposed to extreme conditions, such as:
poor ventilation, temperatures below 5 °C or above 35 °C.
•
When installing the appliance make sure that the four feet are stable and resting on
the floor, adjusting them as required, and check that the appliance is perfectly to level
using a spirit level.
•
If the appliance is being installed on wood or "floating" floors (certain parquet and
laminate materials), secure a 60 x 60 x 3 cm (at least) sheet of plywood to the floor
then place the appliance on top of this.
•
Connect the water inlet hose(s) to the water supply in accordance with the regulations
of your local water company.
•
For cold fill only models: Do not connect to the hot water supply.
•
For models with hot fill: The hot water inlet temperature must not exceed 60 °C.
• The washing machine is fitted with transport bolts to prevent any possible damage to
the interior during transport. Before using the machine, it is imperative that the
transport bolts are removed. After their removal, cover the openings with the 4
enclosed plastic caps.
•
After installation of the device, wait a few hours before starting it so that it acclimates
to the environmental conditions of the room.
•
Make sure that the ventilation openings in the base of your washing machine (if
applicable to your model) are not obstructed by a carpet or other material.
4