Related Manuals for Akicon AK-Hood 30
Summary of Contents for Akicon AK-Hood 30
- Page 1 Installation Guide and Users Manual Built-In Series (Insert Liner) Questions, problems, missing parts? Before returning to the store, call AKICON Customer Service 8 a.m.-6 p.m.,EST, Monday-Friday 1- 302 213-4406 1- AKICONSHOP.COM Rev.2020a...
- Page 3 Important Safety Notice Read all Instructions before Installing and operating this appliance • • DO NOT • • • • DO NOT pors. • • • sure to vent air outside. DO NOT or garages. • • • • den utilities. •...
- Page 4 Important Safety Notice Read all Instructions before Installing and operating this appliance • • • • • • • • • • • • • • what can happen if the instructions are not followed. WARNING The manufacturer and/or distributor/reseller declines all responsibility in the event of failure to ob- serve the instructions given here for installation, maintenance and suitable use of the product.
- Page 5 Table of Contents USE AND CARE INSTALLATION MAINTENANCE WARRANTY Tools needed: Measuring tape pencil Level screwdriver drivers or drill...
- Page 6 Parts supplied: Flappers Charcoal Filter Qty: 6 PCS 6" Round Duct Connector (Only for 6" round duct connector)
- Page 7 Venting Requirements Height & Clearance • • or other enclosed area. • caps. • aluminum vent is recommended. • Do not use plastic vent. • • Range hood tertop/stove (US Standard: 36”). 3. Distance between the countertop/stove 30”). tion: • •...
- Page 8 Height & Clearance (Continued) IMPORTANT: • • duct. • and caps. • • • • • • Minimum Duct Size: • Calculating vent system length Duct Run Calculation: Duct Run Calcuation example: 0 ft + 9ft + 9ft + 5ft = 23ft used. Deduct 23 ft from 50ft, 27ft Roof cap...
- Page 9 Venting Methods • • IMPORTANT: • • • • Round Duct Range Hood Charcoal Filter Installlation(Optional Ductless) NOTE: 1.Remove grease filters from the hood. 2.Position the charcoal filters onto the side of the motor, aligning the mounting points, turn until it locks. Re-install grease filters.
- Page 10 Electrical Requirements IMPORTANT: • that the ground path is adequate. • sides of the line. • Do not ground to a gas pipe. • Do not have a fuse in the neutral or ground circuit. • • • • must conform to the requirements of the National Severe Injury Hood may have very shape edges.
- Page 11 Installation Excessive Weight INSTALL THE HOOD Require two or more person to move and Due to excessive weight, two or more person is recommended for this step. install this range hood. Spinal or other bodi- ly injuries could occur if it is not followed. Position the duct connector onto the outlet of the hood, use the screws (6) to fix it (ref.
- Page 12 Range Hood Operations • • • • Product List Parts Parts Filters (vary with size) Stainless Steel Body Connector box Rubber Gasket of Duct Connector 12V-7W Trandformer Duct Connector LED 3 W 12V Light Power Cord Control Panel Switch Flat Cover 12uf Capacitor Motor...
- Page 13 Product Dimension Wiring Diagram...
- Page 14 Troubleshooting • • • • • • tom due to shipping damage. • range. • • NOTE:...
- Page 15 Use and Care Information the size of the surface element. warning device such as a tag to the service panel. settings. started. Motor Revolution...
- Page 16 Maintenance help preserve the appearance of the range hood. • ® ® ® ® • cleaning solution onto or into the control panel. Follow directions of the stainless steel cleaner. CAUTION: Do not • ® ® • DO NOT allow deposits to accumulate or remain on the hood. •...
- Page 17 Maintenance (Continued) • • • metal clip. • ture. • WARNING Hazard of Burns! Light bulb become extremely hot when turned on. Touching hot bulbs could cause serious burns.
- Page 18 Warranty TO OBTAIN SERVICE UNDER WARRANTY: You must present proof of original purchase date. product.
- Page 19 Disclaimer Contact Us each individual range hood model.
Need help?
Do you have a question about the AK-Hood 30 and is the answer not in the manual?
Questions and answers