Table of Contents
Advertisement
C
C
AREFREE OF
OLORADO
W
IRING
A
LWAYS DISCONNECT THE ELECTRICAL SOURCES BEFORE WORKING WITH ELECTRICAL WIRING AND COMPONENTS
The 110VAC motorized Carefree SunDay Awning is available with two power options.
a) A single hardwired switch; or,
b) Power Control System. The system offers several options that are not available with the standard
hard wired installation. These options include remote controls; wireless wall switches for interior
installation and the wind-sense auto retract for protection against adverse wind conditions.
Important Notices:
•
Failure to follow the wiring instruction in this publication may void the motor warranty.
•
Wiring must conform to NEC (National Electrical Code) and the prevailing building codes of the area.
•
Do not wire two or more motors to one switch or control box – No parallel wiring.
•
It is strongly recommended that wiring be done by a qualified electrician.
•
The installer must furnish required UL approved
junction boxes, conduit etc. where required.
•
Two versions of the tubular motor are used on the
Sunday
II
awning.
connections, identify the motor (series 1 or 2) then use
the appropriate wire colors listed for that motor. Colors
are identified in the "Wire Legend".
S
S
I
INGLE
WITCH
NSTALLATION
1. Determine the location of the switch and junction boxes. The following cable lengths should act as a
guide for locating the components:
•
8 feet of cable from awning motor (attached to motor);
•
12 feet of 2 conductor 18AWG cable w/ ground and standard grounded plug;
•
The installer must furnish the 3 conductor cable w/ ground from the junction box to the switch box.
2. Attach the appropriate junction and switch boxes in the desired location.
3. Route the cables as shown and connect the wires with standard wire nuts. Be sure to match wire
colors as shown in the diagram below.
Note: Form drip loops at the motor and junction boxes to avoid water following the cables into
the components.
4. Connect wires to the switch and install switch and cover.
Outlet Box
Paddle
Switch
GFCI
Cover
1
Series 2 Motor Wire Colors Shown, If a Series 1 Motor is
Installed, Use the Wire Colors Listed Below.
Motor Wire Legend:
Motor Line #1
Motor Line #2
Neutral
Ground
WARNING
Before
beginning
Mounting
Tab
To
110VAC
#8 x 2
Screw
Strain Relief
Connector
-- To Junction
Box
Motor Wire Color:
Series 1
Series 2
Brown
Black
Black
Red
Blue
White
Yellow/Green
Green
Figure 6. Single Switch Installation.
the
wire
Series 1 Motor
White
Green
Black
D1
D2
D1
8
S
II P
A
UNDAY
ATIO
Series 2 Motor
SunDay022
White
Green
Red
Black
Awning
1
D2
Motor
Rear View
of Switch
SunDay007
052551-001r1
Table of Contents
WNING
.
M
Advertisement
Table of Contents
