Ev-ent Hire 19022 Operating & Safety Manual

OPERATING & SAFETY GUIDE
TURBO OVEN-DIGITAL
240VOLT
Product Code
19022
GENERAL SAFETY
Contact Event Furniture Limited for information
and advice on the suitability and safety of this type
of equipment. There is a risk of injury if you do
not follow the instructions printed in this guide.
This equipment should only be used by a
competent adult who has read and understood
these instructions. Anyone with a temporary or
permanent disability should seek expert advice
before using the equipment.
Keep all children, animals and bystanders away
from the work area. Ensure the floor of the work
area is free from trip hazards and non-slip.
Never use the equipment if you are ill, tired or
under the influence of alcohol or drugs.
Never operate electrical switches with wet
hands.
Always switch off and unplug the equipment
from the power supply before moving or
cleaning.
Check the equipment before use, if it shows
signs of damage request a replacement.
ELECTRICAL SAFETY
The equipment is designed to plug directly into a
standard 240volt, 13 amp socket. Make sure the
equipment and power socket are switched off
before plugging into the power supply.
If the equipment fails to operate or the power cable
or plug become damaged, contact Event Furniture
Limited. Do not try to repair it yourself.
Keep the power cable out of harm's way.
Extension leads should be unwound fully, never
run them through water, over sharp objects or
where they may be a trip hazard.
Use a suitable RCD (Residual Current Operated
Device) to reduce the risk of electric shock.
OPERATING GUIDE
Position the unit where it is to be used and ensure
that it is level. Apply the brakes on the two
braked castors.
Oven Control Panel
Temperature Display – Shows the preset
temperature. When used with "temperature"
button, shows actual oven temp for 5 seconds.
Shows cooking modes and error codes.
Grill/Broil Button & LED – Switches between
'Baking Mode' & 'Grill/Broil Mode'.
Temperature Adjustment Knob – Allows
manual adjustment of oven temperature.
Programme Button & LED – Used to enter the
'Programming Mode'.
Temperature Button & LED – Shows actual
oven temperature for 5 seconds on the
Temperature display. LED on when heating.
LED flashes when displaying temperature.
Time Display – Shows cook time in full minutes
From 180 to 1 and then in seconds for final
minute only.
On/Off/Stand By button & LED – Press On/Off
button once to turn oven on. Press & Hold
On/Off button for 2 seconds to turn oven off.
Time Adjustment Control – Manual adjustment
of cooking time.
Light On/Off button – Turns oven light On/Off
Start/Stop button & LED – Pressing the
start/stop button switches between 'Time Start' &
'Temporary Pause Modes'. LED will flash when
timer is paused. When in the cooking cycle,
pressing the Start/Stop button for 2 seconds will
end the cooking cycle.