Advertisement
KIT INCLUDES:
SLIDING DOOR
• 5 – 46-3/4" x 6-3/4" tongue and groove
• 1 – 46-3/4" x 6-3/4" groove only
• 1 – 46-3/4" x 5-3/4" groove only
INSTALLATION NOTES:
• It is recommended to have the stall panel in its final location before
installing the lumber kit.
• Install Sliding Door first.
• The beveled edge of the boards must be facing outward and the
flat edge of the boards facing inward.
• A rubber mallet may be used to secure the boards tightly without
damaging them.
GROOVE
TONGUE
SLIDING DOOR
1.
Install 5 – 46-3/4" x 6-3/4"
tongue and groove boards,
with groove towards the
frame. The first few boards
can be installed by leaning
at an angle and sliding in
the channel.
2. Install 1 – 46-3/4" x 6-3/4"
board, with groove only.
Use notch to install final
boards.
3. Install 1 – 46-3/4" x 5-3/4"
board, with groove only.
Make sure the non-
grooved side is towards
the frame. Last board
may need to be cut to
fit properly. Cut must be
made to the flat edge.
4. Secure lumber with 4 - #10
x 1" Phillips screws. It is
important to screw the
lumber in so the boards do
not come out. (Included in
stall hardware)
10TYV014
STALL FRONT PANEL
• 3 – 36" x 6-3/4" tongue and groove
• 1 – 36" x 5-1/4" groove only
• 8 – 46-3/4" x 6-3/4" tongue and groove
• 1 – 46-3/4" x 6-3/4" groove only
• 1 – 46-3/4" x 2-3/4" groove only
STALL FRONT PANEL
1.
2. Install 1 – 36" x 5-1/4"
3. Install 8 – 46-3/4" x 6-3/4"
BEVELED EDGE
4. Install 1 – 46-3/4" x 6-3/4"
5. Install 1 – 46-3/4" x 5-3/4"
6. Secure lumber with 4 -
TOOLS NEEDED:
• Phillips Screw Driver
• Drill
• Rubber Mallet
• Tape Measure
• Circular Saw
Install 3 – 36" x 6-3/4"
tongue and groove boards.
Make sure groove is
towards the frame.
The first few boards can
be installed by leaning at
an angle and sliding in the
channel.
board, with groove only.
Board may need to be cut
to fit properly. Cut must be
made to the flat edge.
tongue and groove boards.
Make sure groove is
towards the flat edge of the
previous board.
board, with groove only.
Use notch to install final
boards.
board, with groove only.
Make sure the non-
grooved side is towards
the frame. Last board
may need to be cut to
fit properly. Cut must be
made to the flat edge.
#10 x 1" Phillip screws. It
is important to screw the
lumber in so the boards do
not come out. (Included in
stall hardware)
REV2 090921
Advertisement
