Pebble Grey Maya Quick Start Manual

CMYK SINGLE
c32 m25 y25 k85 90% black
Maya LED Mirror
Maya 201.30.05
600mmx800mm
GENERAL
THIS PRODUCT CONFORMS TO UK SAFETY STANDARDS AND MUST BE
•
INSTALLED IN ACCORDANCE WITH CURRENT IEE WIRING REGULATIONS
AND BUILDING REGULATIONS (PART P).
THIS PRODUCT MUST BE EARTHED, AND SHOULD NOT BE CONNECTED
•
TO AN UNEARTHED CIRCUIT.
•
ENSURE THAT CONNECTIONS ARE TURNED OFF AT THE CONSUMER
UNIT OR FUSE BOARD BEFORE INSTALLING OR CARRYING OUT ANY
MAINTENANCE.
•
THIS PRODUCT IS FOR INDOOR USE ONLY.
THIS PRODUCT IS IP44 RATED AND CAN BE INSTALLED IN BATHROOM
•
ZONE 2 (AS DEFINED BY THE IEE WIRING REGULATIONS) AND BEYOND.
SEE BATHROOM DIAGRAM.
•
THE PRODUCT IS SUITABLE FOR INSTALLATION IN ZONE 2 OR HIGHER.
•
IF THIS PRODUCT FEATURES REPLACEABLE BULBS THEN REPLACE FAILED
BULBS IMMEDIATELY. ALLOW THE GLASS, LAMP AND FITTING TO COOL
BEFORE REPLACING.
IMPORTANT
To ensure correct function of the sensor this product
MUST be installed with a minimum distance of 150mm
MIN
150mm
between the infrared sensor and any adjacent
worktop, surface, obstruction or tile trim.
• When working at heights, please use a suitable platform to
work from.
Please note: For new installations, check for any electrical cables
•
or pipe work (gas/water) in the vicinity of the intended mounting
point before proceeding with the installation.
•
Ensure that the fixing location is able to take the weight of the
complete fitting.
Wear suitable eye protection when drilling. Be careful when
•
using power tools near water.
INSTALLATION GUIDE
HEX RGB
#363636 54 54 54
Please read these instructions carefully before installation.
HANDLE WITH CARE!
When unpacking never stand the unit on a hard
surface.Always lay flat on a soft surface.
To avoid the risk of electrocution, please turn off
the electricity mains supply before commencing
installation.
Please do not hang or drape clothing or material
over the mirror. LEDs can get very hot and this may
cause a fire risk.
Please do not place objects too close to the LEDs as
this will cause the object to burn or melt.
IEE Bathroom Zones
60CM
zone
2
zone
2
Do NOT strike mirror glass with hard or pointed items. It is
recommended that the product is cleaned with a soft, dry, non
abrasive cloth. Do NOT use cleaning agents or abrasive materials
on any type of finished surface.Do NOT allow moisture to come into
contact with the electrical components. Keep your bathroom well
ventilated where possible.
COMPLIANCE
This product complies with the following safety standards:
BS EN 60598-1: 2008+A11: 2009, EN60598-2-1: 1989
WIRING
This product is designed and manufactured in the Class 1 category,
meaning a ground wire is required.
COLOUR CODING
LIVE Brown
NEUTRAL Blue
EARTH Green & Yellow
201.30.05
60CM
zone
1
zone
2
225cm