Advertisement
Table of Contents
1. Pull spring latch away from
trap handle until the jaws are
fully opened, (releasing from
shipping position)
2. Now with the jaws in open
position (as shown above)
hook short curved end of tail
over top of left jaw, which will
cause the long end of the tail
to be under the left jaw and on
top of the spring.
3. Slide flat metal trigger piece toward
jaws with the points up. Put long end of
the tail that is resting on the spring
through the hole of flat metal trigger.
Move flat metal trigger up about 1 inch.
P.O. Box 538
East Granby, CT 06026 Ph: (860) 844-0101
www.wildlifecontrolsupplies.com
DK-1 Gopher and MOLE TRAP
CAUTION:
ALWAYS WEAR
GLOVES WHILE
SETTING THE TRAP
Advertisement
Table of Contents
Summary of Contents for WCS DK-1
- Page 1 P.O. Box 538 East Granby, CT 06026 Ph: (860) 844-0101 www.wildlifecontrolsupplies.com DK-1 Gopher and MOLE TRAP CAUTION: ALWAYS WEAR GLOVES WHILE SETTING THE TRAP 1. Pull spring latch away from trap handle until the jaws are fully opened, (releasing from shipping position) 2.
- Page 2 DK-1 traps can be made weaker by winding the thumb latch one-half turn further than one ordinarily winds it in setting.
Need help?
Do you have a question about the DK-1 and is the answer not in the manual?
Questions and answers