Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for MULTILANE ML4022-MCB
Summary of Contents for MULTILANE ML4022-MCB
- Page 1 ML4022-MCB Technical Reference MSA Compliant SFP-DD MCB multilaneinc.com...
- Page 2 Table of Contents Introduction ..........................3 Key Features ..........................3 ML4022-MCB Hardware ......................3 3.1 Power-Up ..........................3 3.2 Operating Conditions ......................4 3.3 LED Indicators ........................4 3.4 Low Speed Signals ......................... 4 3.4.1 External I2C ........................4 3.4.2 External HW Control ...................... 5 ML4022-MCB Software ......................
- Page 3 Introduction The ML4022-MCB is designed to provide an efficient and easy method of programming and testing 100G SFP-DD transceivers and active optical cables. It includes a complete user-friendly GUI supporting all features defined by SFP-DD MSA and simplifying configuration processes to enable intuitive memory map programming and testing.
- Page 4 OR banana plug U6 Table 1: Voltage Operating Conditions 3.3 LED Indicators The ML4022-MCB includes on-board LEDs, for quick debugging and monitoring purposes. LEDs are summarized below: LED D1 indicates whether a USB cable is plugged or not. LEDs D2 and D4, colored green and red, respectively, are used for diagnostic purposes: ...
- Page 5 3.4.2 External HW Control Also Low Speed Signals are controllable using an external source, this can be done through control signals pin headers. In this case a jumper should be placed on pin header P19 (HW_CTRL) shown in the image below. Figure 2: External Control Signals The low speed signals circuit shown below shows the connection of these signals to the microcontroller and SFP-DD connector.
- Page 6 4.1 USB Driver In order to be able to communicate with the board, user need to install the USB driver of the ML4022-MCB. This is available on the website under the following link (USB Driver icon): https://multilaneinc.com/products/ml4022-mcb/ Below is a brief guide on how to install the USB Driver:...
- Page 7 Bootloader Accessing in bootloader mode allows the user to reprogram the microcontroller, this is done as described below: 1. Connect a jumper on (J1) situated close to the microcontroller. 2. Connect a USB cable between the PC and Board. 3. Power up the board with a +3.3V supply. 4.
- Page 8 Revision History Revision Date Description 8/24/2020 Initial Version 10/30/2020 Update section 3.4.1: pin header name Update section 3.4.2: schematics North America Worldwide Asia 48521 Warm Springs Blvd. Suite 310 Houmal Technology Park 14F-5/ Rm.5, 14F., No 295 Fremont, CA 94539 Askarieh Main Road Sec.2, Guangfu Rd.
Need help?
Do you have a question about the ML4022-MCB and is the answer not in the manual?
Questions and answers