JVC TH-C5 Service Manual page 10

3.1.3 Removing the DVD changer mechanism assembly
(See Fig. 7)
• Prior to performing the following procedures, remove metal
cover and front panel assembly.
(1) From the top side of the main body, remove the screw E at-
taching the wire protection board to the main board.
(2) Take out the wire protection board, and disconnect the
card wires from the connectors
main board.
Reference:
When attaching the wire protection board, attach the
wire protection board after connecting the card wires to
the connectors (CN401
(3) Remove the four screws F attaching the DVD changer
mechanism assembly on the bottom chassis.
(4) Take out the DVD changer mechanism assembly in the up-
ward direction.
Reference:
When attaching the DVD changer mechanism assembly, align
the holes of the DVD changer mechanism assembly to the pro-
jections d on the bottom chassis.
3.1.4 Removing the rear panel
(See Fig. 8)
• Prior to performing the following procedures, remove the metal
cover.
(1) From the back side of the main body, remove the screw G
and eleven screws H attaching the rear panel.
1-10 (No.MB362)
(CN401 to CN403) on the
to CN403) on the main board.
DVD changer mechanism assembly
F
Projections d
F
E
F
Wire protection board
Fig.7
G
H
Fig.8
CN402
CN401 CN403
Bottom Main
chassis board
Card wires
H
Rear panel