Promise Technology F29000020000101 Quick Start Manual

R K i Vt
ail it nstallation of RaK
R K S
ail it pecificationS
Rack Type Use with 19" equipment rack
adjustable length 600~900 mm (post to post)
Shipping Package Dimensions 370*380*740 mm
Shipping Weight 28 kg
Suitable Devises 3U and 4U enclosure hardware designed for 19" rack
p l
acKage iSt
• Rail Kit Part Number: F29000020000101
• Content of Rail Kit: 1 Pair of Supporting Rail Kit
Cautions
• Do not populate any unit with hard drives until it has been securely
installed in the rack.
• At least two persons are required to safely lift, place, and attach
the enclosure hardware unit into a rack system.
• Do not lift or move the enclosure hardware unit by the handles,
power supplies or the controller units. Hold the system itself.
• Do not install the enclosure hardware unit into a rack without rails
to support the system.
• Only a qualified technician who is familiar with the installation
procedure should mount and install the enclosure hardware unit.
• Mount the rails to the rack using the appropriate screws and flange
nuts, fully tightened, at each end of the rail.
• Do not load the rails unless they are installed with screws as
instructed.
• The rails available for the PROMISE enclosure hardware unit are
designed to safely support that PROMISE enclosure hardware unit
when properly installed. Additional loading on the rails is at the
customer's risk.
• PROMISE Technology, Inc. cannot guarantee that the mounting rails
will support your PROMISE enclosure hardware unit unless you
install them as instructed.
/V /P P 3u/4u e
ess egasus Ro nclosuRe
M e
ounting the nclosure hardware in a
The instructions here apply to VTrak, Vess and PegasusPro 3U and 4U enclosure hardware. The
sliding rail rack mounting hardware is the same for both form factors.
To install the enclosure hardware into a rack with the supplied mounting rails:
1. Check the fit of the mounting rails in your rack system.
2. Adjust the length of the mounting rails as needed.
• The rear rail slides inside the front rail. The rail halves are riveted together and use no
adjustment screws.
• The front-left and front-right mounting rail ends are labeled.
• Be sure the front rail support is on the bottom facing inward
• All rail ends, front and rear, attach at the outside of the rack posts.
• The guide pins at the rail ends align with the holes in the rack posts.
• Use the attaching screws and flange nuts from your rack system. Tighten the screws and
nuts according to instructions for your rack system.
Installing the rails onto the rack
Front left label
Support flange on
the front end of
each rail
1
19"
rack
Front right label
Guide pins on rails align with holes in the rack post