Board Level Description - Coby DTV-102 User Manual

Coby electronic universal remote user manual
Hide thumbs Also See for DTV-102:
Table of Contents

Advertisement

1.3 Board Level Description

The DTV-102 supports one input and two outputs. The input is a standard RF connector, which can be
connected to an antenna with a coaxial cable. The outputs are standard NTSC composite video and left/right
audio outputs, with RCA jack connectors, and a standard RF output; both are provided to insure an easy
connection to any analog TV. The RF output provides video modulated on Channel 3 or Channel 4, as selected
by the on-board switch.
The Audio/Video (A/V) cables provide good picture quality and stereo sound, and should be used if available on
the TV. The A/V jacks are color coded (yellow for video, red for right audio and white for left audio). If the TV has
only one input for audio (mono), connect it to the left (white) audio jack on the converter box (CB) .
The RF jack and coaxial cable provide acceptable picture and mono sound quality. It should be used if A/V
connections are not available on the TV. RF jacks are typically used to connect your TV to terrestrial antenna
sources.
Note: Be sure to use RG-6 coaxial cable when connecting from the antenna to the CB module.
Figure1. Connectors
- 3 -
Introduction
The module also includes an infra-red (IR) receiver and three push buttons to provide front panel control for the
power on/off and channel up/down functions.
The only one LED indicates three possible power states for the converter box:
Powered on and functional
Bright Green LED is ON
In stand-by mode
Dim Red LED is ON
Powered off
Red LED is OFF.
- 4 -
Introduction

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dtv 102 - atsc standard-definition converter box

Table of Contents