Maintenance - Dalton Mobility 100 Operating And Parts Manual

LUBRICATION SCHEDULE
Careful observance of the following lubrication schedule is the best preventative maintenance program for
your spreader. We recommend that you establish a firm program to insure lubrication in strict compliance with
the following schedule. Use only good grade pressure gun type grease unless otherwise specified.
Daily Lubrication Schedule
Drive Line
Conveyor Drive
Ground Drive All Models
Pay particular attention to the daily cleaning and greasing of the telescoping tube assembly.
Weekly Lubrication Schedule
Chains
PTO Shaft
Spinner Gearbox
Monthly Lubrication Schedule
Drive Shaft Splines
Spinner Gear Box
Annual Lubrication Schedule
Wheel Bearings
Gear Boxes

MAINTENANCE

Weekly
Wash Spreader
Check Ground Drive Tire Inflation (22 psi)
Correct Belt Tension
Adjust Tension of Conveyor and Drive Chains (see machine checkout)
Semi-Annually
Tighten Loose Bolts
Replace Worn or Failed Parts
Touch-Up Paint
All Models
Ground Drive 1 bearing, 4 U joints, 2 telescoping tubes
All Models
2 shaft housings, 2 U joints, telescoping tube, and 2 squirts
of SAE 90 oil into jack crank, oil cap.
Oil -- Lubricate Pin Joints with SAE 80-90
Grease – 2 U-joints and Slip Tube
Universal grease on each fitting under spinner hub
Coat with grease or anti-seize compound.
Check to see that oil level is up to oil level plug. Use SAE 90 oil.
Repack
Drain, Flush and Refill with SAE 90 Oil
MAINTENANCE
4 bearings, 2 U joints
6 bearings
5