Proteco PTPS03W User Manual

1. SAFETY TIPS
Warning: Important safety instructions for people, READ CAREFULLY when you see this symbol
This product must only be used for its intended purpose. Any other use is dangerous. Follow all instruc�ons as improper installa�on may result in in serious bodily injury.
Keep these warnings together with the installa�on and opera�on manuals that come with the device.
Always cut off the power before performing any intervention
Always double check the system is properly connected to the earth
Installa�on must be carried out by expert qualified personnel who knows the poten�al hazards associated and must fully comply with the outstanding current regula�ons. Use of the product
must be restricted to its intended use. Any other use is to be considered dangerous and therefore forbidden.
Do not allow children to play with the fixed command devices. Keep any remote control devices (i.e. transmitters) away from children to prevent the system from
being accidentally activated.
Keep the system regularly maintained. Use only Proteco's original spares. Users are strictly forbidden to carry out any changes on the system. Proteco Srl is not liable for any damage resul�ng from improper,
wrongful or unreasonable use.
2. TECHNICAL FEATURES
Power source solar energy + Lithium ba�ery 3.7V, 180mAh
Absorp�on <=12mA
Code type
rolling code
3. DESCRIPTION
Learning Wind
se�ng Se�ng
Wind speed
Light intensity
Light se�ng
5. INSTALLATION
90°
So that the system works properly the device shall be installed in a sheltered area near the awning, where it is possible to monitor the light intensity as well as the wind speed.
Make sure there are no other devices with the same frequency (433,92 MHz) nearby so as not to cause interferences. Use the provided material, paying special a�en�on to the posi�on
(see here above) so as not to invalidate the wind speed values.
6. RADIO CODE LEARNING
220V AC
Powering the control panel, the motor
makes a quick vibra�on and goes
automa�cally to learning mode. Briefly press the learning key
7. WIND SPEED SETTING
Press wind speed key for 2 seconds, Briefly press the speed key,
le� hand figures on the LCD screen a numbering from 0 to 5 is
start blinking displayed
8. LIGHT INTENSITY SETTING
Press light intensity key for Briefly press the light intensity
2 seconds, right hand figures key, a numbering from 0 to 9
on the LCD screen start blinking is displayed
Frequency
Working temperature
Protec�on Class
Fixing
Base
Wind sensors
90°
x1
The motor makes a one vibra�on,
the radio code has been
successfully stored.
Set the value according to the wind speed
(see the table hereby), press once the right
key to confirm. Figures stop blinking and the
se�ng is successfully stored
x1
Set the value according to the light intensity
(see the table hereby), press once the le� key
to confirm. Figures stop blinking and the
se�ng is successfully stored
Sun/wind sensor for awnings
433.92 MHz
-20 C° < +60 C°
IP44
4. DIMENSIONS
Solar panel
222
90°
Ratio between wind speed level
x1
and wind speed in real time
Speed level
0
1
2
3
4
5
Ratio between light level and light intensity in real time
Light level
0
1
2
3
4
User manual
50
63
120
55
90°
Speed in real time
OFF
10Km/h
15Km/h
20Km/h
30Km/h
>40Km/h
Light intensity Light level
5
OFF
6
2000Lux
7
5000Lux
8
10000Lux
9
20000Lux
98
Light intensity
40000Lux
60000Lux
70000Lux
80000Lux
90000Lux