The heated re-circulating water bath with its ergonomic design allows for immediate extinguishing and preliminary decontamination in the 165 gallons of potable water, which can be treated with Encon Safety Products HydrosepÒ QT water preservative. SAF-T-TUB™ FEATURES ¨...
Page 3
1. Place unit at the appropriate site and ensure tank is clean prior to filling. 2. Water in the tank must be protected against bacteria, fungi, algae, staphylococcus and acanthamoeba growth. Encon Safety Products’ HydrosepÒ QT water preservative provides this protection.
OPERATION & MAINTENANCE - Continued Float Switch: Float switch is located inside the instrumentation compartment. See Notes 1 & 2 above. Locate ‘C’ clip at bottom of float switch and remove. Place ‘C’ clip to one side. Remove foam float and clean as required. After cleaning, replace foam float, ensuring plastic ring is orientated downward.
TROUBLESHOOTING SYMPTOM PROBLEM SOLUTION Heater and Pump not working No power to the unit. Check the following: a) Main power source and correct voltage is applied. b) Disconnect switch is in the “ON” position and fuses are not blown. c) Inspect terminals TB1 and TB2. Electrical termination should be tight, free of oxide build-up, and wiring is per wiring diagram.
Page 6
INSPECTION / TEST REPORT Doc. No: 01999901 Revision: A 5 of 10 Issue Date: 08/15/21...
Page 7
Doc. No: 01999901 Revision: A 6 of 10 Issue Date: 08/15/21...
Page 8
Doc. No: 01999901 Revision: A 7 of 10 Issue Date: 08/15/21...
Page 9
Doc. No: 01999901 Revision: A 8 of 10 Issue Date: 08/15/21...
THIRD-PARTY RIGHTS, EXCEPT AS HEREINAFTER PROVIDED. Encon Safety Products warrants that for one year from the date of purchase of any Encon products, the product will be free of defects in materials and workmanship if properly used and cared for or cleaned under normal conditions in accordance with Encon’s use and care instructions and properly installed, if applicable, in accordance with Encon’s installation...
Page 11
DRAWINGS Doc. No: 01999901 Revision: A 10 of 10 Issue Date: 08/15/21...