Table of Contents
Advertisement
Problem:
Remote Control Unit
does not work.
Wireless Mouse
function does not
work.
SERVICE
WARNING: High voltages are used to operate this projector. Do not attempt to open cabinet.
You can often correct operating problems yourself. If the projector fails to work properly, see the "TROU-
BLESHOOTING" section on pages 42 and 43.
If after following all operating instructions, you find that service is necessary, contact the Christie Service Station
or store where you purchased the unit.
Give the model number and explain the difficulty. We will advise you how to obtain service.
The CE Mark is a Directive conformity mark of the European Community (EC).
G Check the batteries.
G Check ALL-OFF switch on Remote Control Unit is set to "ON.".
G Make sure nothing is between Infrared Remote Receiver and Remote Control Unit.
G Make sure you are not too far from a projector when using Remote Control Unit.
Maximum operating range is 16.4' (5m).
G Make sure the code of Remote Control Unit is set to conform to projector.
(See "SETTING" section on page 36, 37.)
G Check cable connection between a projector and your computer.
G Check the mouse setting on your computer.
G Turn a projector on before turning on a computer.
This symbol on the nameplate means the product is Listed by Underwriters
Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety
standards against risk of fire, casualty and electrical hazards.
Try these Solutions
APPENDIX
43
Advertisement
Table of Contents
