CANARMNA RT31 Installation

Questions or Concerns Contact At The Following Phone Numbers Before Returning Product To The Store:
!
SAVE THESE INSTRUCTIONS
SAFETY PRECAUTIONS:
1. ENSURE THE SCREWS AND WALL PLUGS ARE SUITABLE FOR THE WALL INTENDED TO MOUNT THIS
PRODUCT. CONSULT THE QUALIFIED PERSON FOR SAFETY INSTALLATION.
2. CLEAN GLASS WITH WATER ONLY.
3. REQUIRE AT LEAST 2 PERSONS TO SAFELY INSTALL THIS PRODUCT.
NOTE: Product may not look exactly as shown in figures.
INSTALLATION:
Measure
Distance
Back of
the Mirror
Wood
Wall Plug
Screw
Mounting
Bracket
Front of the Mirror
MIRROR
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
INSTRUCTIONS PERTAINING TO RISK OF INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
Mounting
Bracket
Set Screw
Tool
1.
Lossen the set screw to remove the mounting bracket
before installing.
2.
Measure the distance between the hole centers on the
back of the mirror.
3.
Draw 2 horizontal lines on the wall at the desired height.
4.
Mark the wall for the pilot hole locations. Drill 4 pilot
holes at location. Determine the appropriate way (wood
screws for the wooden studs or wall plugs and wood screws
for dry wall) of fastening the mirror to the wall.
5.
Install the mounting bracket to the wall with the wood
screws and wall plugs. Screw head should protrude
approximately 5 mm from hole (this may vary depending on
individual installation).
NOTE: The wall plugs supplied are only suitable for solid
stone/brick walls. For plasterboard walls use special wall
plugs.
6.
Mount the mirror onto the screws fitted to the wall.
Secure the mirror by the set screw with the tool supplied.
Ensure mirror is securely mounted.
TOOLS AND MATERIALS REQUIRED:
Phillips
Wire Cutters
Screwdriver
Tape
Pencil
Measure
RT31
10/20
Spirit Level
Drill