Advertisement
Advertisement
Table of Contents
Summary of Contents for Tiger Tough 34902
- Page 1 34902 - Hino Passenger Bench...
- Page 3 INSTALLATION GUIDE 34902 Passenger’s Bench Hino 268 / 338...
- Page 4 BILL OF MATERIALS ITEM ITEM QUANTITY Seat Back Cover Seat Bottom Cover StringLock You don’t need to take the seat out of the truck to put the seat cover on! We just took it out because we couldn’t get the truck on our design table. General care instructions: 1.
- Page 5 1 - Install Seat Back Cover q 1.1 - Pull the seat back cover down over the seat, making sure that the orange tag faces the door. Turn it 1/2 way inside out before you put it on the seat, then just unroll it down the seat back. q 1.2 - Push the flaps between the seat back and the seat bottom.
- Page 6 2 - Install Seat Bottom Cover q 2.1 - Put the cover over the seat bottom with the two long flaps at the back. q 2.3 - Run the strings down under the seat bottom and fasten with the orange StringLock. The tighter you pull the strings, the better your seat cover will fit! q 2.4 - Push the two long flaps between the seat back and bottom and run them under the seat bottom.
- Page 7 THE STRINGLOCK Run one string through the channel on the end of the StringLock. Pull the string tight, pulling the StringLock towards one edge of the seat. Press the string into the clamp, locking it in place. Run the second string through the StringLock just like the other one.
Need help?
Do you have a question about the 34902 and is the answer not in the manual?
Questions and answers