AEG L8WEC166R User Manual page 30

30 www.aeg.com
In the display, the indicator of the
operating phase starts flashing and the
detergent percentage indicator goes off.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
12.8 Starting a programme
with the delay start
1. Touch the Delay Start button
repeatedly until the display shows the
desired delay time. The indicator
comes on.
2. Touch the Start/Pause button.
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts.
The ProSense estimation
starts at the end of the
countdown.
Cancelling the delay start
after the countdown has
started
To cancel the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows
3. Touch the Start/Pause button again
to start the programme immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pause button again
to start the new countdown.
12.9 The ProSense System
load detection
After touching the Start/Pause button:
1. The detergent percentage indicator
goes off, the indicator
2. The ProSense starts the laundry load
detection to calculate the real
programme duration. The time dots
flash.
3. After about 15 minutes the display
shows the new programme duration:
the time dots stop flashing.
The appliance adjusts automatically
the programme duration to the load
to achieve perfect washing results in
the minimum possible time. The
programme duration could increase
or decrease.
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
The ProSense System is not
available with some
programmes, such as Wool/
Handwash, programme
without wash phase and
programmes with short
cycles.
12.10 Programme phase
indicators
.
When the programme starts the indicator
of the running phase flashes and the
other phase indicators are steady on.
E.g. the washing or pre wash phase is
running:
When the phase ends the relevant
indicator stops flashing and is steady on.
The next phase indicator starts flashing.
E.g. the rinse phase is running:
.
During the washing cycle, the appliance
mixes the detergent, the stain removal
for fabric treatment and/or the fabric
flashes.
.