Sealey LB001 Instruction Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMP P OR R TA TANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
TH H E P P RO O DUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PE E RS S ON N AL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
Familiarise yourself with the applications, limitations and hazards of the ratchet load binder.

 Maintain the ratchet load binder in good condition (use an authorised service agent).
 Maintain correct balance and footing. Ensure the fl oor is not slippery and wear non-slip shoes.
 DO NOT operate the ratchet load binder while standing on the load.
 DO NOT operate the ratchet load binder if any parts are missing, as this may cause failure and/or possible personal injury.
 DO NOT use the ratchet load binder for a task it is not designed to perform.
 DO NOT make any modifi cations to the ratchet load binder.
 DO NOT exceed the rated capacity of the ratchet load binder.
 DO NOT allow untrained persons to operate the ratchet load binder.
 DO NOT use the ratchet load binder when you are tired or under the infl uence of alcohol, drugs or intoxicating medication.
 DO NOT allow untrained persons to operate the ratchet load binder.
WARNING! operate the handle with caution. Keep your body clear of the path of the handle as it may whip, causing possible

personal injury.
 Prior to each use inspect the ratchet load binder. Replace or repair damaged parts. Use recommended parts only. Unauthorised
parts maybe dangerous and will invalidate the warranty.
 Familiarise yourself with the regulations regarding the size and number of chain systems required for securing loads to lorries etc.
 Periodically check the tension of the ratchet load binder, re-tighten if required. Tension may decrease due to load settlement during
transport.
 DO NOT allow the ratchet load binder to bear against an object whilst under tension. This will cause a side load.
 Use the ratchet load binder in a well lit location.
 WARNING! DO NOT use an extension (cheaters) bar. An extension bar can overload the ratchet load binder with too much tension,
which may damage the ratchet load binder and may also cause the handle to snap back quickly when the ratchet load binder is
attempted to be released, causing possible personal injury. Further personal injury maybe caused if the extension bar slips or whips
off the handle.
 WARNING! The warnings, cautions and instructions referred to in the manual cannot cover all possible conditions and
situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this
product, but must be applied by the operator.
2. INTRODUCTION
Manufactured from heat treated, drop-forged steel for added strength. Suitable for clamping, binding, anchoring and tying down large loads.
Ideal for farmers and commercial drivers. Fitted with 354mm handle for extra leverage.
3. SPECIFICATION
Model No: ...................................... LB001....................LB002
Working load: ...............................2500kg.................. 4200kg
Breaking strength: ........................8636kg...................8636kg
Chain size: ............................. 7.9-9.5mm............9.5-12.7mm
Handle length: ............................. 354mm...................354mm
Hook: ............................................Double...................Double
4. OPERATION
NOTE: Ensure all Safety Instructions in Section 1 are read and understood and carried out before use and save the instructions and
warnings for future reference.
4.1. ATTACHING THE RATCHET LOAD BINDER
4.1.1. Turn the pawl to the neutral position, to disengage the ratchet load binder gear.
4.1.2. By hand, unscrew the ratchet load binder hooks, ensuring not to exceed the maximum extension length.
4.1.3. Arrange chains over load to be secured.
4.1.4. Attach the ratchet load binder hooks to the chain while taking up as much slack as possible.
© Jack Sealey Limited
2500KG CAPACITY RATCHET LOAD BINDER
7.9-9.5mm, 4200KG CAPACITY RATCHET
LOAD BINDER 9.5-12.7mm
MODEL NO:
Wear protective Wear safety
gloves footwear
Original Language Version
LB001, LB002
Wear protective
clothing
LB001, LB002 Issue 2 05/07/21