Room Temperature Regulation | Quick Guide - Programming wireless thermostat
The thermostat shows RUR.
The receiver unit´s L-LED switches to yellow and selec-
table channels light up green. Select channel by pressing
desired channel key. The selected channel flashes green.
Repeat steps 5-10 for the other thermostats in the facility.
EN.33.C.140.1401
2
Press Mode on the thermostat until the "checkmark" is
shown in the display.
Check that the selected channels are shown in the
display. Confirm with Mode. The thermostat switches to
normal view.
Complete the programming by pressing the L-key where-
upon the L-LED goes out.
The programming of the thermostats is now completed. For a more detailed as-
sembly instruction, see supplied instructions or www.lksystems.se.