Advertisement
Quick Links
Quick Guide - Programming wireless thermostat
Connect the actuators to the bottom row of terminal
plugs marked
.
Make sure that the radio link is connected to the receiver
unit.
Remove the back of the thermostat by pressing the lock-
ing with a screwdriver or similar.
Room Temperature Regulation | Quick Guide - Programming wireless thermostat
. Note! Not in the row marked
Plug in the receiver unit.
Press the L-key for at least three seconds until L-LED
lights up green.
Remove the plastic from the battery of the thermostat.
EN.33.C.140.1401
1
Advertisement
Summary of Contents for LK Systems ICS-RF
- Page 1 Room Temperature Regulation | Quick Guide - Programming wireless thermostat Quick Guide - Programming wireless thermostat Connect the actuators to the bottom row of terminal Plug in the receiver unit. plugs marked . Note! Not in the row marked Make sure that the radio link is connected to the receiver Press the L-key for at least three seconds until L-LED unit.
- Page 2 Room Temperature Regulation | Quick Guide - Programming wireless thermostat The thermostat shows RUR. Press Mode on the thermostat until the ”checkmark” is shown in the display. The receiver unit´s L-LED switches to yellow and selec- Check that the selected channels are shown in the table channels light up green.