Arlec KSS501 Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

KSS501 scroll saw inst.

22/12/04

2:10 PM

Page 2

Scroll Saw

KSS501

Instruction Manual

Important! Please read these instructions carefully before use.

Due to continuous research and development the specifications herein are subject to change without notice.

Table of Contents

Need help?

Do you have a question about the KSS501 and is the answer not in the manual?

Questions and answers

Summary of Contents for Arlec KSS501

Page 1 KSS501 scroll saw inst. 22/12/04 2:10 PM Page 2 Scroll Saw KSS501 Instruction Manual Important! Please read these instructions carefully before use. Due to continuous research and development the specifications herein are subject to change without notice.
Page 2 KSS501 scroll saw inst. 22/12/04 2:10 PM Page 3 SAFETY INSTRUCTIONS WARNING! When using power tools, the following safety instructions must be observed to reduce the risk of personal injury and property damage. Please read and observe the following instructions before use.
Page 3 KSS501 scroll saw inst. 22/12/04 2:10 PM Page 4 IMPORTANT NOTES RECOMMENDED SAW BLADES Please read before using this tool • Blades suitable for this machine are pinned end blades with dimension of 124mm from pin to pin. • This tool is designed for DIY (Do it Yourself) consumer home use only and is covered by a 2 year replacement warranty.
Page 4 KSS501 scroll saw inst. 22/12/04 2:10 PM Page 5 b) Insert the end of the blade through the • Ensure that the guard is fitted correctly as shown below. It is supplied with your machine unfitted for access hole in the table until you can hook protection in transportation.
Page 5 KSS501 scroll saw inst. 22/12/04 2:10 PM Page 6 OPERATION INSTRUCTIONS The work table can be fitted to the left for bevel cutting up to 45 degrees Switching On and Off Press the green “I” button to switch on From the 0 degree or horizontal cutting position.
Page 6 KSS501 scroll saw inst. 22/12/04 2:10 PM Page 7 Combination straight and curved cuts Upper arm bearing is accessed by If the combination of straight and curved lines is removing screws from upper arm top cover and lifting off cover.
Page 7 * 24 month guarantee applies for non commercial with Arlec’s recommendations and within such voltage and use only. current limits as are specified by Arlec in relation to the * Warranty excludes product. Arlec will at its own option make good, replace...
Page 8 © This instruction leaflet is subject to copyright and must not be reproduced, copied or otherwise used in any way or for any purpose without the consent in writing of the owner, Arlec Australia limited (A.C.N. 003 118 787). CPIN644...