Advertisement
Quick Links
Advertisement
Summary of Contents for NAVTEK NRDD
- Page 1 Made in China...
- Page 2 Only a qualified electrician can do the wire connection according to the technical standard and circuit diagram. The power must be cut off and no display in LCD before inspecting or repairing. If the original power supply cord is damaged, an OEM replacement may be ordered through your NAVTEK distributor.
- Page 3 4. A filter drier should always be used and should be replaced regularty. And each type of refrigerant Use with the NAVTEK digital scales to prevent over filling of recovery/reclaim cylinders. must have its own filter. For the sake of ensuring the normal operation of the unit, please use high quality filter drier specified by our company.
- Page 4 Category III: R12, R134a, R401C, R406A,R500, R1234YF Category IV: R22, R401A, R401B, R402B, R407C, R407D, R408A R409A, R502, R509 Category V: R402A, R404A, R407A, R407B, R410A, R507, R32 220V-230V AC, 50/60Hz 110V-120V AC, 50/60Hz 6.5A 38.5bar/3850kPa(558psi) 32~104°F 368x252x297mm 11.4kg...
- Page 5 open open stops rotating. Digital Control Board...
- Page 6 9.Observe the reading of the lowpressure gauge when it reaches to -20inHg, after 20 seconds, LP cutoff opens and the machine shuts off. 7.Press the " START" button to start machine. Disconnect 8.Turn the knob to recover,...
- Page 7 leve setting based on level 4.Press the "START" button to start machine. 5.Turn the knob to "Recover".
-
Page 8: Correct Disposal Of This Product
NAVTEK NAVTEK NAVTEK NAVTEK control board Refer to section 6 of OPERATION MANUAL on page 3. Could restart with pressure rise. NAVTEK NAVTEK Correct Disposal of this product: 3.Press "START" button to start machine, then it starts This marking indicates that this product should not be disposed with other household wastes throughout the EU.
Need help?
Do you have a question about the NRDD and is the answer not in the manual?
Questions and answers