Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for CDA HCC310
- Page 1 Manual for Installation, Use and Maintenance Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu...
- Page 2 Dear Customer, Thank you for choosing one of our products. The warnings and tips given below are intended to pro- tect your safety and that of others. They will also help you make the most of your appliance. Keep this booklet in a safe place. It will be useful if you, or anyone else, have any questions about use of the appli- ance.
- Page 3 IMPORTANT WARNINGS AND TIPS When unpacking the appliance make sure that it is not damaged. If you have any doubts, do not use the appliance but consult your supplier or an engineer. The packing materials (plastic bags, expanded polystyrene, nails, bands etc.) must not be left within easy reach of children, because they are a possible source of dan- ger.
-
Page 4: Control Panel Description
Ceramic Griddle Figure 1 FEATURES - Electrical insulation Class I. COOKING POINT 1. Hot plate - 1300 W CONTROL PANEL DESCRIPTION 2. Hot plate control knob 3. Hot plate control lamp... - Page 5 Remove any residual glue carefully, without using abrasive substances, to avoid scratching the surfaces. Clean the cooking surface carefully. Switch the griddle on by turning the power setting knob to the maximum position (11-12) for about 15 minutes to remove residual working greases.
-
Page 6: Tips For Grilling
Place the food on the radiant zone and check the cooking by eye. Turn off the griddle by turning the knob to position “0”. As the radiant zone remains hot for some time after the hob is... -
Page 7: Cleaning And Maintenance
The control knob may be removed for cleaning but care should be taken not to damage the seal. CLEANING THE CERAMIC GRIDDLE Make sure that the cooktop is switched off before cleaning it. Remove any encrustation. Remove dust with a damp cloth. -
Page 8: Installation Instruction
This cooktop can be built into a working surface 30 to 40 mm thick and 600 mm deep. In order to install the ceramic griddle into the kitchen fixture, a hole with the dimensions shown in fig. 3 has to be made, keeping in considera-... -
Page 9: Fastening The Appliance
FASTENING THE APPLIANCE Each ceramic griddle is supplied with a set of tabs and screws fasten it on units. Cut the unit (as shown in figure Stretch gasket “D” over the edge of the hole made, being careful to overlay the junction edges. -
Page 10: Electrical Section
IMPORTANT: Installation must be carried out according to the manu- facturer's instructions. Incorrect installation may cause harm and damage to people, animals or prop- erty, for which the manufacturer accepts no responsibility. DETAILS Connection to the electric power sup- ply must be carried out by a qualified technician and following the appro- priate safety regulations;... - Page 11 Before carrying out any work on the electrical section of the appli- ance, it must be disconnected from the mains. REPAIRS Replacing the supply cable Turn the cooktop over and unhook the terminal board cover by inserting a screwdriver into the two hooks “A”. Open the cable gland by unscrewing screw “F”, unscrew the terminal screws and remove the cable.
- Page 12 Ceramic Griddle Cod. 1101896 ß4...