Summary of Contents for Cascade PH-2020
- Page 1 Cascade Patio Heater Instruction Manual MODEL: PH-2020 PLEASE READ, UNDERSTAND AND FOLLOW BEFORE USING. SAVE THESE INSTRUCTIONS...
- Page 2 Warning: Do not plug into extension cords, power strips, outlet timers, surge protectors, or multioutlet extensions of any type Do not operate the unit near flammable items or in environments where flammable fumes may be present For outdoor use only. This heater is not intended for indoor use.
-
Page 3: Component List
ASSEMBLY Verify that all components listed below are included in the product packaging before beginning the assembly process. Phillips Head Screwdriver Needed for Assembly Component List Base Mount Cover... - Page 4 Assembly Diagram: WARNING: Do not plug the heater into an electrical supply or otherwise attempt to turn the unit on until all assembly steps are completed. Do not connect the heater to an electrical supply or otherwise attempt to turn the unit on if any of the components or the power cord appear to be damaged.
- Page 5 ASSEMBLY INSTRUCTIONS Step 1: Using four M6*30mm screws, attach Tube C to the base and tighten until secure. BASE Step 2: Slide the DECORATION COVER over TUBE C so that it rests on the base. TUBE C DECORATION COVER Step 3: Slide 1 POWER CORD CLAMP, which is meant to hold the power cord in place, over TUBE B. Once the POWER CORD CLAMP is positioned in the middle of TUBE B, tighten the preinstalled screws on the POWER CORD CLAMP to secure.
- Page 6 Step 4: Slide 1 POWER CORD CLAMP over TUBE A. Once the POWER CORD CLAMP is positioned in the middle of TUBE A, tighten the preinstalled screws on the POWER CORD CLAMP to secure. Next, attach TUBE A to TUBE B using three M5*6mm screws.
-
Page 7: Operation
OPERATION The Cascade 1500-Watt Patio Heater utilizes a drawstring cord for operation. Follow the steps below to operate the heater once the unit has been properly assembled: 1) Plug heater into a wall outlet 2) Gently pull the drawstring down until a clicking sound is heard. - Page 8 Cleaning Instructions: Unplug the unit and allow it to cool for at least 15 min before attempting to clean. With the unit unplugged, use a damp cloth to wipe down the exterior of the unit. Do not attempt to clean the heating elements. Allow unit to fully dry before use.