Summary of Contents for Mountain MTN-12000
- Page 1 Model No: MTN-12000 Jump Starter and Portable Power Source User Manual & Safety Instructions Made in China...
-
Page 2: Important Safety Instructions
WARNING: Read all instructions before operating this product. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. SAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS Avoid dangerous environments. Don’t use appliances in damp or wet locations. Don’t use this product in the rain or damp locations. - Page 3 Use in a dry location only. Do not attempt to charge the unit if the charger is damaged – return the charger to dealer for repair or replacement. Refer to the "Specific Safety Instructions for Lithium-Ion Batteries" before using or charging this unit.
-
Page 4: Technical Specifications
Never discharge the battery fully. Charge after each use. Always charge at least once every 3-6 months if not in frequent use to prevent over- discharge. TRANSPORTATION OF LITHIUM-ION BATTERIES Always check all applicable local, national, and international regulations before transporting a unit containing a lithium-ion battery. -
Page 5: Components And Controls
COMPONENTS AND CONTROLS Engine Start Socket Battery Meter TOP VIEW 15V 10A DC Output Port Main Power Button FRONT VIEW LED Work Light USB2 Output USB1 Output Recharging Input PARTS LIST ORDERING PART# PART DESCRIPTION Battery Box KTIXD8008-P1 Intelligent Jumper Cable KTI74395-P3 100-240V, AC Wall Charger Adaptor KTIHD4903-P4... - Page 6 KTIHD4903-P4 KTIHD4903-P5 CHARGING INIDICATOR The battery box of MTN-12000 has 4 indicator lights to determine the amount of power in the unit. Press Main Power Button to activate the lights. The blue indicator lights will flash one by one when the unit is charging. A solid light indicates a complete level of charge.
- Page 7 Recharging battery after each use will prolong battery life; Frequent heavy discharges between recharges and/or overcharging will reduce battery life. Recharged the battery box with supplied wall charger(KTI74395-P3) and USB charging cable KTIHD4903-P5. Make sure all other unit functions are turned OFF during recharging, as this can slow the recharging process.
- Page 8 WARNING: NEVER press “BOOST” button when RED LIGHT illuminates. WARNING: The cable is for jump-starting only through the Engine Start Socket MTN-12000 battery box. DANGER: Never leave the jump starter connected to your vehicle’s battery...
-
Page 9: Running/Charging Usb Devices
IF GREEN Light blinking: Car battery voltage is too low. Press the “BOOST” button on black control box. Once GREEN indicator is on, crank the engine within 30 seconds. IF No Light is on, no Beep sounds: Damaged battery or no battery. Make sure all connection is correct, then press the “BOOST”... -
Page 10: Care And Maintenance
Check connection to AC or DC power source. Confirm there is a functioning AC or DC current. Unit will not operate The Jump starter’s internal battery may be completely discharged. Charge the unit following the directions. The vehicle battery may be damaged, manufacturer suggests that you have your vehicle’s battery tested by a qualified battery service technician.
Need help?
Do you have a question about the MTN-12000 and is the answer not in the manual?
Questions and answers