e-controls E-Detector Noiseless Instruction Sheet

e-Detector Noiseless
Motion sensor with transistor output for ceiling mounting
Product reference: DP.801110-010
e-Detector Noiseless is a motion sensor for ceiling
mounting, used to detect motion through the detection
of heat changes coming from bodies in motion in the
covering area. The device is including an infrared sensor
that detects with high precision any movement in a room
or zone in a building.
The product includes an optocoupled transistor output
that avoids any noise of the traditional mechanical relays,
and has been designed to be connected at a voltage digital
input of a system to monitor the motion detected.
Product description
e-Detector Noiseless is a motion sensor for celing mounting
used to detect people or bodies in motion in a building.
The device has an infrared motion sensor that detects any
movement with a very high precision and a transistor output
type is used to connect the device to a voltage digital input,
that activates every time a valid movement is detected.
The output becomes active during 5 seconds after a valid
detection. The device has a potentiometer to adjust the
sensitivity of the motion sensor providing a very flexible
Mounting instructions
The device has an enclosure for flush mounting on roof
ceilings.
Mounting instructions:
1. Drill a 65mm diameter hole on the ceiling.
2. Connect wires on the correct terminals:
• Connect the power supply to the +/ ~ y -/ ~ terminals.
• Connect the transistor output + and - to the digital
input terminals, respecting the polarity.
3. Adjust sensibility detection potentiometer on the side of
the device, to the desired value.
4. Clip the springs and insert the product into the hole,
releasing the springs when placed in the hole.
5. Power up the supply voltage and check the red LED indicator
is switched on during some seconds (warm up time).
Wiring diagram and mechanical description
Digital
+
Input
+/~
12-24V
-/~
Electronic Intelligent Controls, S.L.
C/ Murcia, 35 F
e-controls e-controls
R
e-Detector Noiseless
Motion detector transistor output
Ref. DP.801110-010
AC 12-24 V, 46mA
DC 12-24 V, 16mA
+
Output
Supply
Input
IP20
+/~
-/~
08830 Sant Boi de Llobregat Tel.: +34 93 652 55 21 www.e-controls.es
Barcelona, Spain
device installable in any environment.
A red LED indicator in the front cover of the device blinks
shortly when the device is detecting motion. The pushbutton
is used to disable the LED indictor function, avoiding lighting
it when a movement is detected. To do this, press the front
pushbutton between 2 to 5 seconds to enable/disable this
function.
Caution:
• The device can't be installed over shelves, behind curtains,
near heat/cool air handling units and avoid direct sun
radiation over the device.
• Disconnect the device from the power supply before
mounting or moving the sensor.
• Do not leave cables peeled or turned around the device.
• Do not connect the device with the hands wet.
• Do not open or drill the device
• Keep the device and cables away from humidity and dust.
• Clean the front cover with a water moisture soft cloth.
Lateral view
WARRANTY VOID
IF BROKEN
Detection
_
+
Motion
sensitivity
adjustment
1
Fax: +34 93 652 55 22 info@e-controls.es
Instruction Sheet
Front view
Motion
sensor
Pushbutton
Motion
indicator
© 2015 e-Controls®
EN