Download Print this page

Smart Technologies SMART Table ST203i Instruction Manual

Replacement lamp module

Advertisement

Quick Links

FRU-20-01032-20
Replacing the lamp on your
SMART Table™ ST230i
This Kit Contains
• Replacement Lamp Module
These instructions guide you through the replacement of the projector lamp in your
SMART Table™ ST230i. The average life of a projector lamp is 2000 hours. When the
projector lamp has been used for 2000 hours or more, the following message appears
on your SMART Table's surface:
It is time to replace the lamp. Use the procedure in the User's Guide to replace
the lamp as soon as possible.
After 2100 hours of use, the following message appears on your SMART Table's
surface for 10 seconds, and then the projector turns off:
The lamp has exceeded its service life! The projector will not turn on until you
replace the lamp.
NOTE
In some situations, the projector lamp may start to dim before 2000 hours of use.
Replace the projector lamp in these situations as well.
To replace the lamp, you must:
disconnect the cables and vent hose from the projector (page 3)
remove the projector and bracket from inside the cabinet (page 5)
replace the projector lamp module (page 7)
reattach the projector to the bracket (page 9)
attach the cables and vent hose to the projector (page 9)
reset the lamp timer (page 10)
Tools Required (but not included)
• Phillips® No. 2 screwdriver
• 5 mm hex key

Advertisement

loading
Need help?

Need help?

Do you have a question about the SMART Table ST203i and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Smart Technologies SMART Table ST203i

  • Page 1 FRU-20-01032-20 Replacing the lamp on your SMART Table™ ST230i This Kit Contains Tools Required (but not included) • Replacement Lamp Module • Phillips® No. 2 screwdriver • 5 mm hex key These instructions guide you through the replacement of the projector lamp in your SMART Table™...
  • Page 2 Wear protective eyewear while changing the lamp. Failure to do so can cause injury or loss of eyesight if the lamp shatters or bursts. – Use only replacement lamps approved by SMART Technologies. Contact your authorized SMART reseller for replacement parts.
  • Page 3 F RU -2 0- 01 03 2- 20 – R E P L A CI NG T H E L AM P O N Y O U R S M A R T T A B L E S T2 30 I –...
  • Page 4 F RU -2 0- 01 03 2- 20 – R E P L A CI NG T H E L AM P O N Y O U R S M A R T T A B L E S T2 30 I 5.
  • Page 5 F RU -2 0- 01 03 2- 20 – R E P L A CI NG T H E L AM P O N Y O U R S M A R T T A B L E S T2 30 I NOTE Re-attach the plastic hose shroud to the projector if it falls off while disconnecting the vent hose.
  • Page 6 F RU -2 0- 01 03 2- 20 – R E P L A CI NG T H E L AM P O N Y O U R S M A R T T A B L E S T2 30 I 2.
  • Page 7: Replacing The Projector Lamp Module

    F RU -2 0- 01 03 2- 20 – R E P L A CI NG T H E L AM P O N Y O U R S M A R T T A B L E S T2 30 I Replacing the Projector Lamp Module After you remove the projector from the bracket, follow these instructions to replace the lamp.
  • Page 8 F RU -2 0- 01 03 2- 20 – R E P L A CI NG T H E L AM P O N Y O U R S M A R T T A B L E S T2 30 I 5.
  • Page 9 F RU -2 0- 01 03 2- 20 – R E P L A CI NG T H E L AM P O N Y O U R S M A R T T A B L E S T2 30 I Replacing the Projector Assembly Once the new lamp module is installed, replace the projector assembly on the mounting bracket.
  • Page 10: Resetting The Lamp Timer

    10 | F RU -2 0- 01 03 2- 20 – R E P L A CI NG T H E L AM P O N Y O U R S M A R T T A B L E S T2 30 I Resetting the Lamp Timer After you replace the lamp, reset the lamp timer.
  • Page 11 11 | F RU -2 0- 01 03 2- 20 – R E P L A CI NG T H E L AM P O N Y O U R S M A R T T A B L E S T2 30 I Adjusting the Table Surface Image If your projector’s image has become misaligned, you can adjust the SMART Table surface image using the colored knobs on top of the projector mount.
  • Page 12 ©09/2011 SMART Technologies ULC. All rights reserved. The SMART logo, SMART Table and smarttech are trademarks or registered trademarks of SMART Technologies ULC in the U.S. and/or other countries. All other third-party product and company names may be trademarks of their respective owners. Patent No. US6141000; US6326954; US6540366; US6741267;...