Download Print this page

rodac RASB8000N Operation Manual

Download this manual

Read this manual before use

Do not fasten the hanger

When the spring

breaks, the sage pin

pops out from the

spring case and

collides with one of

the pins, to stop the

drum rotating.

Bottom hook

RODAC RASB8000N

Operation Manual

even don't adjust under its

capacity)

Always attached a

secondary support

cable or chain.

Turn CW.(

For increasing the

spring tension by

allen key.

Turn CW.(

For decreasing

about 1.0cm

(Keep the hex

and turn slowly,

)

Need help?

Do you have a question about the RASB8000N and is the answer not in the manual?

Page 1 RODAC RASB8000N Operation Manual Read this manual before use Do not fasten the hanger Always attached a secondary support cable or chain. When the spring breaks, the sage pin pops out from the Turn CW.( spring case and For increasing the...
Page 2 Prohibition Caution Incorrect use of the spring balancer could cause personal injury. Observe instruction in the manual and use the balancer correctly. Never stand under the spring balancer. Prohibition of disassembly. Never put the spring balancer in fluid.
Page 3 Don’t twist and rub the cordage with cable during travel. Don’t load over its capacity. Take the tools off while remove the spring balancer, prevent the devise drop down. Please remove the spring balancer and tools if rest for a long time. Remove the spring balancer and devise before arranging the tension.
Page 4 Leave some slack in the secondary support cable or chain to allow the balancer to rotate freely. The slack must be a suitable length so that the balancer will stop within 10cm when falling in case of failure of the hanger or the fitting.
Page 5 1.Installation Attached the spring balancer to the steady place. (2) Please attached a secondary support cable and install to the steady position. (3) Install the devise within the capacity to the bottom hook. (4) Please adjust the tension within the capacity after install the devise. 2.