Summary of Contents for GW Instek GRC-1201
- Page 1 ISO-9001 CERTIFIED MANUFACTURER REMOTE CONTROLLER GRC-1201 USER MANUAL GW INSTEK PART NO. 82RC-12010MA1...
- Page 2 TABLE OF CONTENTS equipment, and maintenance procedures at any time without notice. Good Will Instrument Co., Ltd. No. 7-1, Jhongsing Rd., Tucheng City, Taipei County 236, Taiwan. This manual contains proprietary information, which is protected by copyright. All rights are reserved. No part of this manual may be photocopied, reproduced or translated to another language without prior written consent of Good Will Corporation.
- Page 3 The GRC-1201 is a special remote controller for the standard signal generator GSG-family. The main purpose of the GRC-1201 is to read the information stored in the memory of GSG-family. Before the remote controller is used, such information as the carrier frequency , output level, modulation factor, and modulation mode must be written into the memory from the front panel of the signal generator.
- Page 4 GRC-1201 User Manual GRC-1201 User Manual Display functions 2-digit 7-segment LED in MEMORY block. MOD ,PILOT indicator in MOD block. LOCK indicator in CURSOR block. External dimensions 189 (W) x 38 (H) x 97 (D) mm (case size) SPECIFICATIONS Cable length = 1.9 m approx.
- Page 5 GRC-1201 User Manual GRC-1201 User Manual : Turns modulation ON or OFF. FRONT PANEL (2) MOD key When LED indicator is light, the modulation is ON : Select pilot signal to deliver or not. (1) PILOT key (3) Address display...
- Page 6 GRC-1201 User Manual GRC-1201 User Manual CONNECTION METHOD Turn off the POWER SW of the signal generator , set the connector at the tip of the GRC1201 cable to the REMOTE connector on the rear panel of the signal generator , and turn on the POWER SW.
- Page 7 GRC-1201 User Manual NOTE: (1) When the value of higher digit in MEMORY block is “9” , pressing of key is ignored. In the same way , pressing of the key is ignored when the value of the higher digit is “0”.
Need help?
Do you have a question about the GRC-1201 and is the answer not in the manual?
Questions and answers