Advertisement
FIGURE 3 An open disk tray
5. Hold the tray handle, and firmly pull it toward you
until the disk tray, along with the SSD, comes out of
the chassis completely. Put the disk tray assembly
aside.
6. Unpack the replacement SSD. The replacement SSD
comes assembled with its own disk tray.
7. Insert the disk tray (with the replacement SSD) into
the disk bay until the drive locks in the connector on
the SAS backplane.
8. Close the handle, and lock the tray by moving the
orange disk tray lock to the right (lock) position.
9. Verify that the new drive's status LED flashes green.
When the drive's status LED shows solid green, you have
completed inserting an SSD in the SmartZone 300
controller.
Closing the Front Bezel
After you complete installing a module, remember to
close the front bezel to prevent access to the modules
and protect them from dust and dirt.
If the controller is mounted in a rack, before completing
the following steps, grab the side handles on the
controller, and push the controller back into the rack.
Secure the controller to the rack using the rack fasteners.
Perform the following steps to close the front bezel.
Copyright
©
2018 ARRIS Enterprises LLC. All rights reserved.
Published November 2018, Part Number 800-71883-001 Rev A
1. With the controller in front of you, gently lift the bezel
and push it back onto the front panel of the
controller.
2. Gently press the bezel against the front panel until it
clicks into place.
The bezel should now be flush against the front
panel, completely covering it.
©
2018 ARRIS Enterprises LLC. All rights reserved.
ARRIS, the ARRIS logo, Ruckus, Ruckus Wireless, the Ruckus logo, and
the Big Dog design are trademarks of ARRIS International plc and/or
its affiliates. All other trademarks are the property of their respective
owners.
Page 2 of 2
Advertisement
