Advertisement
Quick Links
Advertisement
Summary of Contents for Seago SMTD-201710V2EP
- Page 1 SMART DRY dehumidifier User manual Model: SMTD-201710V2EP...
- Page 3 9-10...
- Page 4 The Seago Smart Dry is ideal to use on a boat, file rooms, storage unit or in any room/space that needs to maintain a dry environment. This compact unit can be le�...
- Page 5 Must be reliably grounded or plugged into a If the supply cord is damaged it must be grounded outlet. replaced by the manufacturer, service agent or similarly qualified person in order to avoid hazard. This unit must be turned on/off in the correct This unit must not be used with an extension or way.
- Page 6 B a c k c ov e r C ontrol b oa rd Top c ov e r A ir d e fle c tor F ilte r L e ft-s ide p la te F ront c ov e r R ig ht-s ide p la te Wa te r ta nk P owe r c ord...
- Page 7 C) Empty water tank: When the water tank is full the indicator will light and an audible beep will sound 15 �mes then the unit will enter standby mode. Empty water tank to restart the unit with the previous se�ngs. D) Air deflector opens and closes by hand.
- Page 8 A) For best performance posi�on the unit in accordance to the below guideline. ≥5 0 cm ≥2 0c m ≥2 0 c m B) The power outlet supply should be in accordance to the label on the rear of the unit.
- Page 9 Connect drainage pipe to outlet Remove the water tank Replace the water tank. The drainage pipe will fit in the slot on the water tank. NOTE: For con�uous drainage to work the unit must always be higher than the drainage pipe. The drainage pipe should not have any kinks, twists or knots and must allow water to flow freely.
- Page 10 Power indicator: POWER When connected to power outlet the indicator with show green. Water tank full indicator: FULL When the water tank is full the indicator will show red and an audible beep will be heard. The unit will go into standby mode un�l the tank is emp�ed. Timer indicator: TIMER When in �mer mode the indicator will show green.
- Page 11 A) Do not remove the float switch this will stop the unit running. B) To rinse the tank use cold or warm water. C) Ensure the water tank is fully engaged. If the tank is not fully engaged the unit will not run.
- Page 12 Cau�on: To avoid an accident disconnect the power cord from the power outlet before maintenance. A) Keep air filter clean: The air filter gathers dust restric�ng air flow. To achieve the best opera�on and efficiency clean the filter regularly. Clean the filter every 1 to 5 days if ambient space is dusty. Clean the filter every month if ambient space is reasonably clean.
- Page 13 G) Serious pitch and pump or excessive slope will cause opera�on problems, i.e. opera�ng noise will become higher. Residual water in the unit will run over. H) Storing the Smart Dry: Ensure the water tank is empty and the power cord is unplugged. Coil up the power cord.
- Page 14 Use the table below to solve common problems before contac�ng support. Ensure power outlet is Power cord is unplugged. working. Connect plug to power outlet. Unit is switched off Switch on unit Unit does not operate Ensure water tank is in Power light and Full light place and fully engaged.
-
Page 15: Noise Level
MODEL SMTD-201710V2EP POWER SUPPLY AC 220-240/50Hz 10L (30°C RH80%) DEHUMIDIFYING CAPACITY 5.5L (27°C RH60%) RATED INPUT POWER 200W AIR VOLUME 100m³/h WORKING SPACE 10-20m³ WORKING TEMPERATURE 5-32°C REFRIGERANT R134a NOISE LEVEL 42dB COMPRESSOR PISTON TYPE CONTROL MODEL ELECTRONIC WATER TANK CAPACITY 1.8L...
Need help?
Do you have a question about the SMTD-201710V2EP and is the answer not in the manual?
Questions and answers