Table of Contents
Advertisement
Quick Links
THANKS FOR CHOOSING ONE OF OUR SEMI KITS!
What you have here is a semi kit, where all components are soldered in the boards and you will be doing
the final assembly of mechanical components, testing and calibration.
This is a quite complex build. If you are not an experienced DIYer you might find yourself in trouble. Some
steps are not obvious, and some components tricky to solder, so even if you're an experienced DIYer
please read the steps thoroughly before starting.
Also, even if this is a semi kit, TROUBLESHOOTING SKILLS ARE MANDATORY and you should be an
experienced DIYer with basic schematics reading skills.
This semi kit is not suitable for beginners.
HAVE FUN!
VACTROLS
Mind polarity when placing the Vactrol. Short leg for negative in silkscreen
VTL5C10
LDR1, LDR2, LDR3, LDR4, LDR5, LDR6
DIP SWITCH
Solder the DIP switch at S100. This switch will set levels for both channels of output.
POWER CONNECTOR
Place the power connector at "POWER" at silkscreen side, ensuring it is facing out from the edge of the
PCB.
COMMUNICATION PORTS
Solder X100 and X101 IDC connectors , ensuring the position is correct: they must be soldered at
silkscreen side, same side as the rest of components and facing out of the board.
Longest connector is in Pots bag.
VCA EXTENSION CONNECTOR
Solder the VCA expander connector at VCA_CON. ensuring it is facing out from the edge of the PCB.
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Befaco HEXMIX PRESOLDERED V2
Summary of Contents for Befaco HEXMIX PRESOLDERED V2
- Page 1 THANKS FOR CHOOSING ONE OF OUR SEMI KITS! What you have here is a semi kit, where all components are soldered in the boards and you will be doing the final assembly of mechanical components, testing and calibration. This is a quite complex build. If you are not an experienced DIYer you might find yourself in trouble. Some steps are not obvious, and some components tricky to solder, so even if you're an experienced DIYer please read the steps thoroughly before starting.
- Page 2 You’re nearly at the end, but the next part is critical and takes a good bit of concentration. If you’re feeling a bit strained, a break would definitely help. Mechanical parts are really delicate and will need your full attention. Please read all steps crefully: A MISTAKE FROM HERE WILL UNLEASH A DESOLDERING MAYHEM ON YOU.
- Page 3 5) Doublecheck all the soldering and pay special attention to the solder points near SMD parts. Just in case. 6) Put the knobs on the potentiometers. - Please read user manual carefully before connecting your module. ENJOY YOUR NEW BEFACO MODULE!
Need help?
Do you have a question about the HEXMIX PRESOLDERED V2 and is the answer not in the manual?
Questions and answers