Advertisement
Advertisement
Table of Contents
Summary of Contents for Thunder 5000 Series
- Page 1 ONE TOUCH TIME OUT REPROGRAMMING...
- Page 3 Control Module Time-Out Reprogramming 1. Press the small button and large right button (close) at the same time for approximately 10 seconds. Pressing these buttons at the same time will cause the module to enter the time out programming mode. After entering programming mode, the led will flash and the number of flashes represents the timing cycle it is in per the following table.
Need help?
Do you have a question about the 5000 Series and is the answer not in the manual?
Questions and answers