Advertisement
A quick guide to operation
(for more detailed instructions and
specification about the printer, see enclosed
manufacturer's leaflet)
Ensure that there is a paper roll in the printer.
Bench Top Autoclaves:
Connect the grey printer lead into the
printer and the multi-pin connector into the
autoclave printer port. (When looking from
the front, this will be on the rear left hand side
of the unit). Connect the black power adaptor
to the printer and plug into a suitable 13 amp
socket. When the indicator light comes on,
the printer is ready for use.
Portable Autoclaves:
Connect the grey printer lead into the printer and the multi-pin
connector into the autoclave printer port. Connect the black
power adaptor to the printer and plug into a suitable 13 amp
socket. When the indicator light comes on, the printer is ready for
use.
Replacing Paper Roll:
To replace the paper roll simply open the lid by pulling the clear
plastic lever forward and upwards. Remove the spool of the old
paper. Reel off a few centimetres of paper from the new roll and
keep approximately 5 cm outside the printer. Place the new roll
into position with the paper feeding from the bottom front and
with the leading edge over the serrated tear bar. Gently close the
lid until it locks into position.
To re-order printer rolls (pack of 10 rolls)
Call 01254 844 103
and quote part number 279505
NB: No batteries required. UK only.
.
Advertisement
