Troubleshooting - Fenger FIR-433 User Manual

TROUBLE SHOOTING
Please read this user manual carefully before using the IR Remote Control Extender. If you still
have difficulties to use the system, consult the following instructions, which will guide you to
solve most common problems.
Make sure both Receiver and Transmitter are plugged into a standard electrical outlet.
Make sure the power adaptor and IR Extender Mouse are plugged into the connectors properly.
Check if the Remote Control is out of battery.
When the Remote Control is operated, the IR LED of the Transmitter does not flash
Make sure your Remote Control is able to align the Transmitter IR window.
Make sure nothing
Transmitter.
Make sure the distance between the Remote Control and the Transmitter is within 5m.
Move to another location and try it again.
When the IR LED of the Transmitter is continuously illuminated
In a few cases, the Transmitter may be disrupted by interference and cannot, therefore,
pick up the signals it receives. If this is the case the IR LED will be continuously
illuminated and the Transmitter must be relocated. This interference is caused by
equipment in the vicinity such as dimmers, energy-saving light bulbs, IR alarms and so
on.
When the Remote Control is operated, the IR LED of the Receiver does not flash
Make sure the Transmitter is no more than 30m from the Receiver install.
Make sure the Receiver is pointed at the front of the A/V appliances that you want to
control.
Move to another location and try it again.
Make sure the distance between the Receiver and the A/V appliances that you want to control
is within 4m.
Make sure the IR extender mouse is placed in front of the IR window of the A/V appliances
that you want to control.
is blocking the path between the Remote Control and the
© 2012 FENGER Marketing | 20120623-EN-V1.0
Specifications subject to change without notice.