AVer RM-N7 Manual

Re mot e Cont ro l
The remote control requires two (2) "AAA" size batteries (supplied), make sure batteries
are installed properly before use. You can access all the features of AVerVision PL50 with
the remote.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10 )
(11)
(fig. 1.4)
Name
(1) POWER
(12 )
(2) CAMERA
(13 )
(14 )
(3) RECORD
(15 )
(16 )
(17 )
(4) CAPTURE
(18 )
(19 )
(5) VISOR
(20 )
(21 )
(22 )
(23 )
(6) ROTATE
(7) MENU
2
ENGLISH
Function
Turn the unit on/standby.
Camera mode displays the video signal
from the built-in camera.
Start/Stop audio & video recording. Video
recording can only be saved either in a
SD memory card or a USB flash drive.
Capture still image in Camera mode. In
continuous capture mode, press this
button again to stop.
Call the Visor submenu. Visor covers part
of the presentation screen and allow
presenter to reveal the material as desire.
In the Visor submenu, the following
options are available.
ON/OFF – select to run/cancel the Visor.
Press to move to the next selection.
Shade – set the opacity level of the
covered area. The shaded area will
completely turns black when it is set to
level 100. Press to move to the next
selection.
OK – press for the setting to take
effect. If you select ON, upper part of the
presentation screen is slightly exposed.
Use the ▲,▼,◄, & ► buttons to reveal
more of the covered area; and OFF will
close the submenu.
To turn off Visor, press
Rotate the image by 90° in Camera
Mode and Playback mode.
Open and exit the OSD menu.
again.