Media Lifter Removal And Installation; Media Sensor Assembly Removal And Installation - Panasonic JU-475-4 Service Manual

12.13 Media Lifter Removal and Installation

(1) Remove th e clamp assembly as described in
section 12.5.
(2) Remove the lifte r shaft clamping retaining ring
draw o ut th e lifte r shaft.
(3) Remove the media lifte r.
(4) Reverse the above procedure to reinstall.
12.14 M e d ia Sensor A ssem b ly R em o val and
Installation
(1) Remove th e PCB as described in section 12.1.
(2) Remove th e c a rtrid g e g u id e assem bly as
described in section 12.7.
(3) Draw out the pins o f the media sensor assembly
fro m th e f o llo w in g lo c a tio n s on th e J3
co n n e cto r: N o 8 ,10, 12.
A t th a t tim e, draw out the pins w ith liftin g the
stopper on the connector.
(4) Remove the media sensor assembly m ounting
screw and take out the media sensor assembly.
(5) Reverse the above procedure to reinstall.
-2 2 -