Relax-A-Lounger PARKER 1 Assembly Instructions

Hide thumbs Also See for PARKER 1:

Finally, stretch and pull down the rear cover evenly before securing

the velcro strip to the seat base. Repeat if necessary for a better fit.

OPERATING YOUR UNIT

While sitting, simply pull the handle to release and access the footrest position.

The footrest will release once the handle is pulled.

While sitting, simply lean and push back against the backrest to recline at your

desired position.

Push down and lean forward to restore the footrest and backrest into the original

positions.

Footrest Position

Recliner Position

4 of 4

Rev.09272016

PARKER 1

TOLL FREE 1-877-693-8866 LIFESTYLE SOLUTIONS

Table of Contents

Do you have a question about the PARKER 1 and is the answer not in the manual?

Page 1 While sitting, simply lean and push back against the backrest to recline at your desired position. Push down and lean forward to restore the footrest and backrest into the original positions. Footrest Position Recliner Position PARKER 1 4 of 4 Rev.09272016 TOLL FREE 1-877-693-8866 LIFESTYLE SOLUTIONS...
Page 2 PARTS AND HARDWARE ASSEMBLY INSTRUCTIONS Avoid using sharp objects such as a knife to cut open packing as you may accidentally damage the upholstery. CAUTION: At least two adults are required to safely complete performing this task. Other lifting attempts may risk back injury due to large and heavy part(s). Carefully unpack and place parts on a clean flat surface.