TACSWAN 85-028 Quick Start Manual

QUICK START GUIDE
CS CAMERA FIL TER SYSTEM & CS CAMERA FIL TER SYSTEM &
CS CAMERA PHOTOGRAPHY SYSTEMS CS CAMERA PHOTOGRAPHY SYSTEMS
QUICKL Y MOUNT A VARIETY OF FIL TERS ONTO CAMERA
LENSES UP TO 82 MM
P/N 85-028 | 85-029
MOUNTING CAMERA LENS
ADAPTOR TO CAMERA
1. Pull the spring-loaded grip ring until it's wide
enough to fit over desired camera lens.
2. Release the spring-loaded grip ring so that
it's securely attached to camera lens.
PUTTING FIL TER INTO FIL TER
HOLDER
1. Slide 4 in / 100 mm filter of choice into
the slot of the filter holder. Use care when
sliding filter into holder to avoid damage to
the filter.
2. Repeat with a different filter on separate
filter holder if desired.
ATTACHED FIL TER HOLDER TO
CAMERA LENS ADAPTOR
1. Note the four spring-loaded tabs on
mounting side of filter holder.
2. Press the filter holder firmly onto the
raised grooved ring of the camera lens
adaptor until it clicks in place. Be sure it
is firmly attached prior to use to avoid
damage to filter.
3. NOTE: you can stack additional filter
holders on top of one another by
repeating step 2 above.