O.S. engine OCA-3100HV Instructions

ESC PROGRAMMER
INSTRUCTIONS
Corresponding ESC:
OCA-3100HV
OCA-3070HV
The OCP-3 is a programmer for the corresponding ESCs listed
above for the brushless motors. By using an optional extra ESC
Programmer OCP-3, Settings of ESC can be programmed quickly
and securely to meet model s specific requirements.
The governor system of this ESC does not conform to
FAI F3A regulations.
Disable the function when you participate in the
competitions based on FIA F3A regulations.
Set the each parameter of the ESC as follows.
Connecting the programmer
Connect OCA-3100HV/OCA-3070HV to the ESC socket of
OCP-3, and a battery (4.8〜7.4V) to the BATT socket of
OCP-3.
OCA-3100HV/OCA-3070HV
Brown-red-orange wire
Setting items
The following items can be set with OCP-3.
Setting items (model type: airplane)
Battery type
Battery Cut-off
Cut-off type
Motor timing
Acceleration
Drive Frequency
Reverse Rotation
Brake Force
How to set the ESC using OCP-3
Disconnect the battery from the ESC.
Connect a battery (4.8〜7.4V) to the socket BATT socket of
OCP-3.
Select a setting item by pressing the UP and the DOWN
buttons.
Select or change the setting item by pressing the LEFT and
the RIGHT buttons.
Any chosen value of setting is memorized in the ESC
automatically one by one without requesting you any further
action to memorize the value in the ESC.
※
No electronic sound is emitted from the OCP-3
and the motor when you press the buttons.
IMPORTANT: Before attempting to operate your OCP-3, be sure to read through this
instruction manual.
HOW TO USE HOW TO USE
to be connected to change the
program using OCP-3
Brake Speed
Start Power
Active Freewheel
Current Limit
Governor settings
Motor Type
Throttle Mode
Restore Default
Notes on operation
WARNINGS
Never touch or allow any part of the body to come into
contact with any rotating part while operating.
Sudden rotating may cause serious injury.
Be careful with some receivers the motor may rotate for a moment when
the power puts on.
Be sure to check the ESC and all the movements of model
controls before attempting flight.
Incorrect settings or using of unsuitable model may cause to lose model
control which is very dangerous.
NOTE
Do not disassemble. Do not open the ESC case.
Opening of the case may cause damage inside components and render it
irreparable.
This programmer especially designed for the left shown O.S.
ESCs and cannot be used with other ESCs.
Operation of the edit buttons
ESC
BATT
(4.8Ｖ〜7.4V)
LCD
Select a setting item by pressing the UP or the DOWN button.
The LEFT and the RIGHT buttons are to select each item in
the setting or to change the setting.
Battery type
Setting choice : LiPo or NiCd
Default setting : LiPo
Select the battery type and number of cells with the LEFT and
the RIGHT buttons.
Setting a number of the battery cells: AUTO
In case NiCd is selected, pass the setting item
The cut-off voltage is automatically fixed at 50% of an initial
value.
Battery Cut-off
Setting range : 2.9V~3.2V
Default setting : 3.2V
Set the cut-off voltage when you select LiPo battery with the
LEFT and the RIGHT button.
Cut-off type
Setting choice : Reduce power by 50% or
Switch OFF (stop the motor)
Default setting : Reduce power by 50%
Select how to cut off the power when voltage of the battery
drops to the set value of cut-off voltage with the LEFT and the
RIGHT buttons.
Editing Buttons
.