Turning On The Gpsmap 376C - Garmin GPSMAP 376C Owner's Manual

Turning On the GPSMAP 376C

The first time you turn on your new GPSMAP 376C, the GPS
receiver must collect satellite data and establish its current location.
To ensure proper initialization, the GPSMAP 376C is shipped from
the factory in AutoLocate mode, which allows the receiver to "find
itself" anywhere in the world. Before you turn on the unit to start
initialization, be sure that the antenna is rotated up as shown on
page 1, and it has a clear and unobstructed view of the sky to receive
satellite signals.
To turn the GPSMAP 376C on and off:
1. Press and hold the POWER key. When the unit turns on, a
tone sounds and the Warning Page appears.
Warning Page
2. Read the warning, and then press ENTER to continue.
3. To turn off the GPSMAP 376C, press and hold the POWER
key again.
GPSMAP 376C Owner's Manual
G S
ETTING TARTED
Adjusting the Backlight and Volume
You can adjust the backlight to see the display better. If you are
using the optional External Speaker with 12/24-Volt Adapter Cable
with the GPSMAP 376C or you have headphones plugged into the
headphone jack, you can adjust the volume level of the audio output.
To adjust the backlight level or volume:
1. Press and quickly release the POWER key.
2. Press up on the ROCKER to increase the brightness or
press down to decrease. Press right to raise the volume or
left to lower.
3. Press ENTER or QUIT to close the Backlight/Volume
adjustment window.
4. Press MENU to view the options menu.
Battery time remaining and power source indicator
Backlight
adjustment slider
> T O GPSMAP 376C
URNING N THE
Volume
adjustment slider
3