Advertisement
HOW TO USE
After charging fully, your trimmer is ready to use.
1.
Initially ensure the switch is pushed to "OFF".
2.
Check the blade is not damaged and is clean.
3.
Apply the oil to the blade before each use.
4.
Attach the position comb to the hair trimmer.
5.
Adjust the comb to achieve preferred result.
6.
Push to the switch to "ON".
7.
Switch off the trimmer after use.
TRIMMING WITHOUT THE POSITION COMB
Trimming without the attachment will trim the hair length to approximately 0.5mm.
Remove the attachment combs before using.
Take care DO NOT press too hard otherwise scalp/personal injury may occur.
HOW TO CLEAN
Clean the appliance after each use to ensure continued performance.
Ensure the trimmer is switched off and not connected to mains power.
DO NOT submerge the unit or comb in liquid.
DO NOT use abrasive liquids or detergents.
Wipe unit with a damp clean cloth, to remove any residue build up, dry thoroughly with a soft dry
cloth. DO NOT use direct to heat to dry.
1. Push the switch to "OFF'.
2. Remove the position comb.
3. Holding the main body, position your thumb against the blades and push them away
from the main body.
4. Remove/brush away any hair trimmings from the blade.
5. Replace the blade after cleaning once all parts are completely dry.
Advertisement
