Do you have a question about the AS 30 WeedHex 140 and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for AS MOTOR AS 30 WeedHex 140
Page 1
Operating Instructions Weed remover AS 30 WeedHex 140 AS 30 WeedHex 160 From serial No.: AS 30 WeedHex 140: 028720100001; AS 30 WeedHex 160: 036120100001 Translation of the original operating instructions Release: 15/10/2020, V1.1EN www.as-motor.de...
Page 3
AS 30 WeedHex 140 AS 30 WeedHex 160 Contents EN Operating instructions 2 EC/EU Declaration of Conformity 3 EN Attached illustrations Basic information Request the unpacking the machine and instructions by your dealer as part of the pre-sale service! Please, fill in all data concerning your device.
AS 30 WeedHex 140 AS 30 WeedHex 160 Operating instructions Contents EN Operating instructions 1.3.7.2.1 Brushing in corners...........11 1.1 Introduction..................4 1.3.7.2.2 Open area brushing..........11 1.1.1 Note well................4 1.3.7.3 Manner of device operation.........12 1.1.2 Safety Regulations..............5 1.3.7.3.1 Brushing in corners...........12 1.1.2.1 User restrictions............5 1.3.7.3.2 Open area brushing..........12...
AS 30 WeedHex 140 AS 30 WeedHex 160 Operating instructions provided with this device form an integral part of it. They must be available at all times, stored at an accessible place where they cannot get destroyed. When selling the machine to another person, the operating instructions must be handed over to the new owner.
AS 30 WeedHex 140 AS 30 WeedHex 160 1.1.2.3 Inspection before use Prior to each use of the device, check tightening of bolts, fastening of the brush on the carrier and all screwed connections of guards, covers and the engine. If you find any deficiency, remove it immediately.
AS 30 WeedHex 140 AS 30 WeedHex 160 Work on steep slopes Devices fitted with four stroke engines may only be operated on less than 20° slope. Otherwise, the four stroke engine may get damaged due to insufficient oil lubrication.
AS 30 WeedHex 140 AS 30 WeedHex 160 1.1.4 Safety Pictograms The user is obliged to keep the pictograms on the machine in a readable state and, in case of any damage, ensure their replacement. Position: Number: Description: Before using the machine, read through these Operating Instructions.
AS 30 WeedHex 140 AS 30 WeedHex 160 1.2.2 Description of the Machine and its Components Fig. 1 The device is built on a frame welded of sheet steel. Two wheels are mounted at the back with independent height adjustment. The tubular handlebars...
=STOP, =MIN, =MAX and main positions get locked by means of a simple press-protrusion system in the lever body. AS 30 WeedHex 140 with engine ZONGSHEN XP140 1. Move the accelerator lever to its position CHOKE. in Fig. 1 ) 2.
AS 30 WeedHex 140 AS 30 WeedHex 160 1.3.5 Stopping the brush in Fig. 1 ) on the right handle. The tool stops, the engine is still running, shift the If you want to stop the brush, release the lever (...
AS 30 WeedHex 140 AS 30 WeedHex 160 1.3.7.3 Manner of device operation When checking the area to be brushed remove all large solid objects (such as stones, sticks, plastic bottles and similar municipal waste) that can be propelled away from the device or damage the device.
AS 30 WeedHex 140 AS 30 WeedHex 160 If you are not sufficiently manually skilled, have the operations done by an authorized service centre. 1.4.1.2 Lubrication Points When selecting from a wide range of oils it is sufficient to select any spray oil. When selecting plastic lubricants (grease) any lubricant intended for water pump lubrication is sufficient.
AS 30 WeedHex 140 AS 30 WeedHex 160 Never use the machine with its flexible air intake hose disconnected, air filter element insufficiently fastened and sealed or the air filter cover loose. The engine could get damaged. 1.4.5 Belt Gears The machine features modern belts, which do not require any particular care.
AS 30 WeedHex 140 AS 30 WeedHex 160 1.4.7 Servicing intervals Activity Prior to each use Prior to long-term storing Checking engine oil level yes, according to engine operating instructions change Engine air filter cleaning yes, check every 5 hours...
AS 30 WeedHex 140 AS 30 WeedHex 160 1.4.8 Troubleshooting Problem Cause Solution The engine will not start No fuel in the tank. Fuel up. The fuel valve is closed. Open the fuel valve. The device has been tilted - oil got into the Change the air filter, unscrew the spark plug and pull the engine starter air filter.
AS 30 WeedHex 140 AS 30 WeedHex 160 1.4.9 Storage After switching the engine off, let the device cool down for at least 20 minutes. Then you may store it in a dry and ventilated room. Always eliminate all problems of the device before you store it so that the device is always in a safe-to-operate state.
Page 18
AS 30 WeedHex 140 AS 30 WeedHex 160 2 EC/EU Declaration of Conformity AS-Motor Germany GmbH & Co. KG Ellwanger Straße 15 D-74424 Bühlertann www.as-motor.de EC/EU Declaration of Conformity Manufacturer: AS-MOTOR GERMANY GmbH & Co. KG Address: Ellwanger Straße 15; D-74424 Bühlertann...
Page 19
AS 30 WeedHex 140 AS 30 WeedHex 160 Attached illustrations AS 30 WeedHex 140 AS 30 WeedHex 160 Device frame Right wheel Plastic wing nut Starter handle Handlebar holder tube Left wheel scraper Left handle Fuel tank cap Handlebars Right wheel scraper...
Page 20
AS 30 WeedHex 140 AS 30 WeedHex 160 Cardboard box Cardboard insert Rear face of the box Front face of the box Rubber flap and bag with manuals Device Protective guard Protective guard holder Plastic binding tape fixing the handlebar handle to the handlebar holder...
Page 21
STOP - turn engine off - engine idling speed - maximum engine speed CHOKE - open choke Only for AS 30 WeedHex 140 with engine Zongshen XP140 Fig. 4: Throttle lever positions PUSH Fig. 5: Pulley control lever positions...
Page 22
AS 30 WeedHex 140 AS 30 WeedHex 160 1L+1R 2L+1R 3L+2R 2L+2R 4L+3R 3L+3R 4L+4R 5L+4R 5L+5R Fig. 6: Adjusting position of the wheels...
Page 23
AS 30 WeedHex 140 AS 30 WeedHex 160 1 mm Fig. 7: Dirt scraper - adjusting the clearance 15 mm Fig. 8: Brush wear and setting of the protective guard...
Page 24
AS 30 WeedHex 140 AS 30 WeedHex 160 Fig. 9: Tensioning belt pulleys 45 mm Fig. 10: Tensioning pulley spring...
Page 25
AS 30 WeedHex 140 AS 30 WeedHex 160 Fig. 11: Lubrication Points...
Page 26
AS 30 WeedHex 140 AS 30 WeedHex 160 Fig. 12: Safety labels - control lever Position on the machine No.: Position on the machine Fig. 13: Safety labels – Combined sticker Fig. 14: Information pictogram – washing...
Page 28
AS-Motor Germany GmbH & Co. KG Ellwanger Straße 15 D-74424 Bühlertann www.as-motor.de TALL GRASS MOWER AND TWO-STROKE ENGINE MANUFACTURING PLANT AS-Motor is a leading manufacturer of mowers and tall vegetation and also two-stroke engines. To our customer, we offer professional technology for steep slopes, inaccessible terrain and lawn maintenance.
Need help?
Do you have a question about the AS 30 WeedHex 140 and is the answer not in the manual?
Questions and answers