Advertisement
Quick Links
Advertisement
Summary of Contents for Guest 729825
- Page 1 MODEL 729825 Wireless Transmitter for Guest 501 and 505 Remote Controlled Spotlights INSTALLATION AND OPERATION INSTRUCTIONS IMPORTANT ! READ THESE INSTRUCTIONS BEFORE INSTALLING AND USING THIS PRODUCT KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE Arrow.com. Downloaded from...
- Page 2 CAUTION! MODEL 729825 COMPLIES WITH PART 15 OF THE FEDERAL COMMUNICATIONS COMMISSION RULES. CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE MAY VOID YOUR AUTHORITY TO OPERATE THE SPOTLIGHT! The GUEST 729825 wireless transmitter consists of: (1) Hand held R.F.
- Page 3 Installing Transmitter Battery Note: Battery is installed when unit is shipped. We suggest that you keep a spare battery on hand to avoid loss of signal. 1. Remove any static charges from your body by touching a grounded metal object. 2.
- Page 4 5. Place the 12 Volt Alkaline A23 battery in location per Figure 1 below paying close attention to the + / - orientation. NOTE: If you wish to change the security code for your light, skip to the section titled: Changing the Security Code –...
- Page 5 Changing the Security Code – OPTIONAL There are 64 codes available in the system. They are selected by means of eight 2- position code switches. The code switches are located in the wireless transmitter. NOTICE LL RADIO ONTROLLED EMOTE POTLIGHTS ARE FACTORY SET TO THE SAME SECURITY ’...
- Page 6 Code Switch Location and Adjustment The code switches are located inside of the transmitter on the backside of the circuit board, above the battery. 1. Remove any static charges from your body by touching a grounded metal object. 2. Remove wireless transmitter from console mounting bracket, by slightly bending the tab back to release the transmitter from the bracket.
- Page 7 12 volts DC. Disconnect power to the spotlight for 5 seconds then reconnect power and press the green On/Off button to register the transmitter frequency. If you still have a problem, call the Guest Company Service Department. See page 10 for contact information.
-
Page 8: Light On/Off
Operation You are now ready to operate the light. For directional control, the wireless transmitter works as shown below: Light On/OFF On the wireless transmitter the light is turned on and off by using the green On/Off button. The light can be turned on with the main wireless transmitter or any secondary wireless transmitters. - Page 9 Mounting the Wireless Transmitter for console control operation 1. Remove the wireless transmitter from the plastic console-mounting bracket by slightly bending the tab back to release the wireless transmitter from bracket. 2. Place the wireless transmitter in the desired location and orientation. Test systems by operating the spotlight in all directions to verify you do not have interference between the locations.
-
Page 10: Troubleshooting
Under normal use, your Guest Model 501 Beamer Remote Controlled Spotlight will provide you with many years of reliable service. If your unit should become damaged by a severe impact, we recommend that you contact the Guest Company Service Department. See page 12 for contact information. - Page 11 If the lower motor makes no sound when it is activated, replace the lower motor. If your light has a problem that is not described above, contact the Guest Service Department for advice (see page 12 for contact information). Be sure to...
-
Page 12: Limited Warranty
LIMITED WARRANTY For one (1) year from the date of original purchase, The Guest Co., Inc. will, at its discretion, repair or replace for the original consumer, free of charge, any parts found defective in material or workmanship. All transportation charges under this warranty must be borne by the consumer.