Husqvarna QSI7134W User Manual page 34

34 www.husqvarna-electrolux.se
Accessories
12.2 Stainless steel or
aluminium ovens
Clean the oven door with a damp cloth
or sponge only. Dry it with a soft cloth.
Do not use steel wool, acids or abrasive
materials as they can damage the oven
surface. Clean the oven control panel
with the same precautions.
12.3 Catalytic cleaning
CAUTION!
Do not clean the catalytic
surface with oven sprays,
soap or other cleaning
agents. It will damage the
catalytic surface.
CAUTION!
Always turn the oven light on
while using the catalytic
cleaning (if applicable).
WARNING!
Keep children away when
you clean the oven at a high
temperature. The oven
surface becomes very hot
and there is a risk of burns.
Spots or discolouration of
the catalytic surface have no
effect on catalytic
properties.
Before activating the
catalytic cleaning remove all
the accessories from the
oven.
The walls with catalytic coating are self-
cleaning. They absorb fat which collects
on the walls while the appliance
operates.
Clean all accessories after each use and let them dry. Use a soft cloth with
warm water and a mild detergent. Do not clean the accessories in a dish-
washer.
Do not clean the non-stick accessories using abrasive cleaner or sharp-
edged objects.
To support the self-cleaning procedure,
heat the empty oven on a regular basis.
1. Clean the oven floor with warm water
and washing-up liquid, then dry it.
2. Set the oven temperature to 250 °C
and let the oven operate for 1 hour.
3. When the appliance is cool, clean it
with a soft and moist sponge.
12.4 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
2
1
Install the shelf supports in the opposite
sequence.